Thread
:
In situ painting? Using POR-15?
View Single Post
#
5
IP: 68.33.43.122
08-20-2019, 10:39 PM
ernst
Senior Member
Join Date: Dec 2009
Location: Baltimore, MD
Posts: 148
Thanks: 59
Thanked 14 Times in 10 Posts
Quote:
Originally Posted by
capnward
I used the Rustoleum high heat paints in spray cans with great success. They cured fine. They covered the rust well after a little wire brushing and vacuuming.
Primer in Gray:
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
and Aged Copper, which is like the Universal Brown but a little lighter, and more metallic.
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
A lot of paints are baked off at the hot end of the manifold, but these are holding up well.
Thank you, good to know. As I said in my previous post, at this point I plan to stick with POR-15 but if something comes up that says this is a bad idea, it is good to know there is an alternative.
ernst
View Public Profile
Find all posts by ernst