Quote:
Originally Posted by goodoldboat
Santa brought me the new MM flange pump for Christmas , waiting for Spring to get to CT , so I can do the install .
I spayed PB blaster on the lower and upper bolts and both water hoses last week .
I had an idea to run engine to to temp prior to heat every thing up prior to removal ?
Good idea or bad ?
John +1 on the 3 inch bolt .. Good install tip .
|
I'm not sure if your instructions came with this info, but mine had a small slip included that said to hand tighten the bolts and then run the engine for a minute to let the part settle into the correct position, turn off the engine and then finish tightening the bolts.