Quote:
Originally Posted by edwardc
...From the picture, the nuts look like ones that come with the modified housing. If so, is the spacer installed too? I can't tell from the pic...
|
Ed-
That pic is of MY Therm setup (albeit an old pic) not Tim's.
And yes, I do have the spacer installed.
Quote:
Originally Posted by Tryoung
...I borrowed a torque wrench from an auto parts store, but I couldn't get it to fit. The wrench was for 1/2"-drive sockets and the 9/16" nut 1/2"-drive socket added enough height to the wrench that the handle hit the top of the engine access door frame. I'll have to see if I can come up with a different setup that fits. In the mean time I cleaned the studs, added a little oil, and tightened the nuts down with my best guesstimate of 25 fp -- which is about as tight as I can get it with my little 6" rachet wrench.
|
Tim-
There IS actually a scientific procedure for figuring out torque values if you don't have a torque wrench. It's explained
here
Neil may be along later with drawings or pics of his own to better explain...