Quote:
Originally Posted by Al Schober
Removal of the reversing gear is covered in the Moyer Manual under Major Overhaul - Part 3, steps 1 thru 4. Do this removal for both engines. You'll end up with two housings and two rotating assemblies (plus a bunch of misc. parts).
The rotating stuff from the old V-drive engine will get installed into the new engine. The new engine gets it's original housing - don't switch housings.
Reassembly is covered in Major Overhaul - Part 6. Read 'General' and steps 3 thru 8 (don't skip over IMPORTANT NOTE .
If a gasket gets damaged, you'll need a bit of extra sealant (permatex 2a).
|
So in a sense all I am doing is swapping out the reversing gear assembly? Right?