Quote:
Originally Posted by edwardc
If you remove the screws holding the engine mounts to the stringers, you can slide the engine and remove it with the mounts attached.
|
Yes would be ideal... Of the 8 screws, 4 are already removed, the 2 below the water pumps do not have heads anymore due to rust, but still hold on (chisel is next once engine is off).. one rear port one has not been attempted yet. one front has been «*rounded*», during previous attempt (the engine mount bolt was cut on that one).
I am stuck at a kiddo swim meet, back to the boat in a couple hours to attempt the recommendation on pushing back the shaft.