Is it possible that when you replaced the cap last year that the little grounding wire to the electronic ignition that slinks out of a little notch under that cap got misdirected away from the notch and minced? Or that the cap you used doesn’t have the notch at all?
I haven’t replaced my cap in a while but I forget if that notch is pre-cut on new caps, or if I had to carve it out myself with a Dremel or rigging knife.
The integrity of that wire is critical to the functioning of the EI. There might even be two of those wires, I forget.
Last edited by tenders; 07-08-2018 at 08:57 AM.
|