Quote:
Originally Posted by rickinnj
There's a bolt and hold-down clamp at the base of the distributor on the reversing gear side. I believe it's a 9/16". If you pull up the 360 view of the engine on the home page and spin it around to the reversing gear end of the motor, you'll see it at the base of the distributor.
Hope that helps
|
hmm.. ok I DID do the right thing.. loosened it enough that I could move the bolt with bare fingers (which I realize is too much), but could not get the dist to budge. Didn't want to try too hard as never done this part before and worried about "doing something" shouldn't.
suggestions?
- once loosened give the clamp a tap with the wrench?
- little MMO to loosen things up?