08-15-2019, 12:28 AM
|
Afourian MVP, Professor Emeritus
|
|
Join Date: Nov 2008
Posts: 3,500
Thanks: 54
Thanked 855 Times in 629 Posts
|
|
Just Curious
Quote:
Originally Posted by SubtoSail
My memory of the carb assembly procedure is to screw in the float seat, drop in the needle, and put the float on. Then verify that the float is resting parallel when held upside down. My float seat is screwed all the way in. I have always screwed it completely in, checked the float, and decided it looked parallel. When I take the carb apart I'll take a picture of this step. Does the float seat normally go all the way in, or does it usually get backed out some to make the float parallel?
Joe
|
What float drop measurement did you use?
TRUE GRIT
|