Thread: Winter rebuild
View Single Post
  #35   IP: 71.7.227.12
Old 02-09-2019, 08:36 AM
Koerk's Avatar
Koerk Koerk is offline
Senior Member
 
Join Date: May 2018
Location: Halifax
Posts: 20
Thanks: 10
Thanked 0 Times in 0 Posts
Back at it again.

Good day, gentlemen. I am now back to work stripping the engine bare. Thanks to Mo. I have been in talks with a local machine shop regarding hot tanking and checking the viability of the block.

So far I have only removed the aft housing and reversing gear, Exposing all the drive gears for the cam shaft, crank shaft, oil pump, and accessory drive.

With the pistons still siezed in the cylinder. I'm wondering if I should continue and attempt to free the pistons now or move forward tearing the crank out and then the cam and finally free the pistons. I'm curious as to your oppions as I'm leaning for the route that yeilds the most progress durring my short time home.

Cheers.
Attached Images
   
Reply With Quote