View Single Post
  #11   IP: 99.30.185.198
Old 09-03-2019, 11:34 AM
thatch thatch is online now
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,079
Thanks: 235
Thanked 257 Times in 138 Posts
I believe that you are about three quarters of the way there in the process of separating the engine from the coupling. If you take a quick look at the aft end of the "rotating Moyer pin-up engine" you will see that there is a large nut on the back of the engine output flange. It will involve sliding the prop shaft aft about 3/4" to gain the clearance needed to lift the engine.
Tom
Reply With Quote