View Single Post
  #3   IP: 45.49.35.172
Old 05-19-2020, 07:47 PM
Ando's Avatar
Ando Ando is offline
Senior Member
 
Join Date: Jul 2019
Location: San Pedro, CA
Posts: 247
Thanks: 333
Thanked 58 Times in 38 Posts
Maybe irrelevant, but if you are curious to know what kind of efi you have there, see if you can read any series of numbers on the left and right side of the face of mounting bracket. This may or may not require the use of a wire brush or sandpaper to get the paint off. It looks like a Facet brand fuel pump, but not really sure which model until and unless there are numbers to be found on the mounting bracket.

Another piece of potentially helpful info is that the efi you do eventually replace this one with should have a PSI of 2.5-3.5 (if I recall my convo with Ken at MMI). My Facet efi is 4.5-5.5PSI (installed by the PO or PPO), but its running and I'm ok with it so far. I have a 74' Cat 27, so that PSI is what was recommended for mine. Yours may require a different PSI. Just be aware that Facet efi's all look alike, but their PSI are different. Something I wasnt aware of until the recent past.
Reply With Quote