View Single Post
  #3   IP: 38.118.52.76
Old 04-13-2005, 09:44 AM
Don Moyer's Avatar
Don Moyer Don Moyer is offline
 
Join Date: Oct 2004
Posts: 2,811
Thanks: 0
Thanked 183 Times in 124 Posts
Jim,

Here are the answers to your questions:

1. Do I take the impeller and shaft out before installing to make it easier to fit the shaft groove into the accessory drive?

Definitely not!

2. Do I put any sealant on the water fittings that I have to install on the pump (taken from the old unit)? If so - what?

You can use any tread sealant that you're accustomed to using on any other tapered pipe thread. If this is your first experience with tapered pipe threads, I'd recommend the old Permatex Aviation brand sealer, or even one of the newer silicone Permatex products. The selection of sealant really isn't critical. You can use most any household pipe dope that you may have lying around.

3. Do I put sealant on the bolts securing the pump to the drive - if so what?

It's a good idea to use the same sealant that you select for the tapered pipe threads since the threads of the mounting bolts are somewhat subject to letting engine oil seep out from the crankcase.

4. Does the brass washer go beside the head of the extender bolt?

Yes.

5. Any other helpful tips.

Not at this time.

Regards,

Don Moyer
Reply With Quote
The Following User Says Thank You to Don Moyer For This Useful Post:
TimBSmith (07-21-2022)