View Single Post
  #3   IP: 172.58.43.133
Old 09-06-2019, 12:34 PM
ajgaines ajgaines is offline
Senior Member
 
Join Date: Aug 2019
Location: Alameda
Posts: 58
Thanks: 10
Thanked 0 Times in 0 Posts
This is the screw that holds the adjusting collar I guess. There's only 1 of 3 in there? I've found it impossible so far to get the 1 1/8 nut off the front. I've used a 24" breaker bar with wrench that gives me about 27" with my full bodyweight into it and nothing budges. It must be close to 400 ft lbs that I'm putting into it. The pipe wrench is eating into the coupling bit by bit. I'm at a loss for what to do because it's slowly remolding the metal on the nut
Attached Images
 
Reply With Quote