Quote:
Originally Posted by Graham
I have to test this personally to confirm, but others here that have installed the same coil have tested it and say it has a resistance of 3.5 ohms
|
Ok.
IF it is under 4Ω then you'll need an external resistor.
More on that here...
Start reading at Neil's post #21
Quote:
Again the only reason I did not go with MMI was that I have friends in town this weekend and needed the boat running with some confidence that I was not going to have any surprises. I'm up in Canada.
|
I understand and we've all been there.
Just wanted to be sure you eventually do it up right or you're in for another failure downstream.
AND usually at the worst possible time too.