View Single Post
  #178   IP: 24.152.132.140
Old 11-24-2018, 08:06 PM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,619
Thanks: 198
Thanked 2,208 Times in 1,425 Posts
A welding jig can be easily fabricated to hold everything in alignment. Off the deck measure the distance of the three holes for each leg from the outboard mounting hole of the transom leg, also the distance between corresponding mounting holes for all four legs. Lay out the dimensions on a sheet of plywood and screw all the pieces where they belong before welding it back together. Not only will this align the rotation of the foot pads but also the dimension between the broken legs. The pads will probably need to be shimmed on the jig to allow for deck camber.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
The Following User Says Thank You to ndutton For This Useful Post:
CajunSpike (11-24-2018)