View Single Post
  #85   IP: 72.194.218.130
Old 04-04-2017, 11:52 AM
JOHN COOKSON JOHN COOKSON is offline
Afourian MVP, Professor Emeritus
 
Join Date: Nov 2008
Posts: 3,500
Thanks: 54
Thanked 855 Times in 629 Posts
To check the sending unit wiring for resistance: Disconnect the wire at the sending unit and the gauge. Run a jumper wire from one end of the wire with the other end near the other end of the sending unit wire. Measure the resistance. It S\B zero ohms.
To check the sending unit for grounding: One ohm meter probe on the body of the sending unit and one probe on battery ground. Use a jumper wire from battery ground to the vicinity of the sending unit if necessary.

TRUE GRIT

Last edited by JOHN COOKSON; 04-04-2017 at 02:06 PM.
Reply With Quote
The Following User Says Thank You to JOHN COOKSON For This Useful Post:
Oldlaxer1 (04-04-2017)