Ok, I'm an idiot.
Was about to post a photo showing the size of the hole in the coupling, that it was 3/4".
The only problem is that I'm using a printed ruler and I didn't start at zero. Started at the edge of the paper.
Starting at zero, the coupling hole is 7/8".
The Moyer part for a 7/8" shaft DOES include a 1/4" keyway.
I'll go back to my closet now.
After the fact note for future reference:
My shaft IS a 3/4" shaft. It also has a 1/4" keyway.
Was unable to find a new coupling with these parameters.
Ordered a 7/8th coupling with 1/4" keyway thinking that was the right size. Did not use it since shaft did not fit right, went back with original part.
:-(
__________________
Bill L.
1972 Ericson 27
Hull #61
Atomic 4
Last edited by CajunSpike; 07-01-2018 at 05:37 PM.
|