View Single Post
  #3   IP: 67.241.137.168
Old 08-28-2018, 08:36 PM
jkaiser77 jkaiser77 is offline
Senior Member
 
Join Date: Jun 2016
Posts: 46
Thanks: 33
Thanked 0 Times in 0 Posts
Thanks, Dave. I'm wondering because an exterior section of my oil pan developed a bit of a rust bloom (where the machine shop that cleaned it forgot to put anti-rust grease on). I angle-grinded the rust off, but it started coming back within a day or two. I angle grinded again, then immediately put Rustoleum Rusty Metal Primer on.

I was worried that once I remove the anti-rust grease from the gasket surfaces they'd also start to rust. But sounds like I don't have to worry about that.
Reply With Quote