View Single Post
  #259   IP: 148.170.241.1
Old 07-11-2011, 12:20 PM
ILikeRust's Avatar
ILikeRust ILikeRust is offline
Afourian MVP
 
Join Date: Sep 2010
Location: Henrico, VA
Posts: 2,202
Thanks: 2
Thanked 23 Times in 21 Posts
HA!

Talk about timing. Hehehe...

I just pushed the button on an order including a Groco bronze sea strainer and associated fittings.

I just decided that was the one I wanted. It's more expensive, but hey, waddya gonna do? What the boat wants, the boat gets. It's a quality item.

I need to take a good look at what I actually am going to need as far as hose and fittings. As I recall, the Moyer FWC kit requires 5/8" hose. And I recently bought a bunch of 1/2".

Then I have to figure out where the sea strainer and heat exhcanger are going to go - not a whole lot of places to hang things in my little engine area. Oh yeah, and some wiring stuff, too - I need to figure out where to locate a bus bar or two. I'm thinking a bus bar is the best way to wire up all the things that need to connect to the engine and batteries, rather than the stack of wires the previous owner had attached to the battery terminals and a couple ground points on the engine.
__________________
- Bill T.
- Richmond, VA

Relentless pursuer of lost causes
Reply With Quote