Thread: Ignition Crank
View Single Post
  #15   IP: 75.82.181.203
Old 11-02-2017, 02:43 PM
CamaroMan CamaroMan is offline
 
Join Date: Oct 2017
Location: San Pedro, CA
Posts: 42
Thanks: 3
Thanked 10 Times in 5 Posts
Quote:
Originally Posted by msmith10 View Post
I have attached (I think) a drawing. *Please note that I am not recommending that you do this yourself. Any use of this drawing is at your own risk. (Dewey, Cheatam, & Howe)
Hi - can u remember what size the actual socket was? I can hardly get a hand round the back of the motor - closest fit I could get was a 12 point 3/4 socket - that seemed to fit just about perfect around the cracnk snout.

I couldnt even tell what else was in there - I have a 13/16 deep socket I bought for $1 im going to try grind, Just hve no idea what the OD of the snout is or the depth of the pin "in" from the snout..

thanks again!
Reply With Quote