|
Hello Art.
I checked both spreaders. The (possibly) filled holes you mention are on both sides of both spreaders. It's difficult to measure where the center of each hole might be, as the shapes are irregular. They are approximately on the centerline of the spreader, and about 2" from the inboard edge. They are in the reinforced section I mentioned in an earlier post, which is about double the wall thickness of the rest of the spreader.
There is no evidence that the 'holes' extended through the reinforced section; inside the spreader there are no welds or other filler where a might have been.
So, it's a bit of a mystery to me what these spots are. I've attached a photo.
Let me know if you need any other information.
jack.
|