View Single Post
  #11   IP: 209.42.139.31
Old 06-21-2020, 02:55 PM
Muntasel Muntasel is offline
Frequent Contributor
 
Join Date: Nov 2019
Location: Mechanicsville
Posts: 7
Thanks: 3
Thanked 0 Times in 0 Posts
So I Don’t have A new coil yet (UPS Teased me with an early delivery notification which dis not happen)
But what I have checked today was fuel vent line which had no blockage...then looking at the coil:
it is a NAPA Product couple if things I measured the resistance on the secondary winding which is 9.18K Ohms kind in the lower end of the 9K-11k as recommended range by Don Moyer on his coil check tutorial video (much appreciated!).
There is also this additional resistor (DALE RH-50 Measured at 1.5 Ohms ) connected to the positive of the secondary winding. Not sure why they installed it, the coil itself has a labeled on the side ‘no external resistor required’ , any ideas?
Is this because I have electronic ignition? I doubt it. I will try the moyer’s coil (As soon as it gets here) and eliminate the resistor and hopefully this will be the end of this dilemma.
I tried to upload a picture of the coil set up but I am not sure if it will show.
Attached Images
 
Reply With Quote