View Single Post
  #5   IP:
Old 05-13-2020, 07:55 PM
Al Schober's Avatar
Al Schober Al Schober is offline
Afourian MVP
Join Date: Jul 2009
Location: Uncasville, CT
Posts: 1,633
Thanks: 9
Thanked 265 Times in 205 Posts
Removal of the reversing gear is covered in the Moyer Manual under Major Overhaul - Part 3, steps 1 thru 4. Do this removal for both engines. You'll end up with two housings and two rotating assemblies (plus a bunch of misc. parts).
The rotating stuff from the old V-drive engine will get installed into the new engine. The new engine gets it's original housing - don't switch housings.
Reassembly is covered in Major Overhaul - Part 6. Read 'General' and steps 3 thru 8 (don't skip over IMPORTANT NOTE.
If a gasket gets damaged, you'll need a bit of extra sealant (permatex 2a).
Reply With Quote
The Following 2 Users Say Thank You to Al Schober For This Useful Post:
Administrator (05-13-2020), Rando1201 (05-16-2020)