View Single Post
  #10   IP: 68.33.43.122
Old 12-02-2019, 09:29 PM
ernst ernst is offline
Senior Member
 
Join Date: Dec 2009
Location: Baltimore, MD
Posts: 148
Thanks: 59
Thanked 14 Times in 10 Posts
Quote:
Originally Posted by JOHN COOKSON View Post
If the boat is back in commission start the engine and run it for awhile till it is good and warm. While the engine is still running loosen the nuts\bolts. The heat + vibration will help loosen them.
When you use the PBblaster tap on the nuts\bolts with hammer after applying to help it penetrate.

TRUE GRIT
That is a great idea. Except that (I hope!), that ship has sailed. I hope that I can do the painting before the boat goes back into the water.
Reply With Quote