Forum: Troubleshooting
05-02-2019, 01:53 PM
|
Replies: 68
Views: 93,045
Thanks for all of the suggestions.
I...
Thanks for all of the suggestions.
I installed a fuel gauge after the polishing filter (which is after the pump) and I am getting 4.5 PSI. I turned the idle air screw in about 1/4 turn and it...
|
Forum: Troubleshooting
04-28-2019, 08:58 PM
|
Replies: 68
Views: 93,045
I have a fuel/water seperator/filter after the...
I have a fuel/water seperator/filter after the tank, a small polishing filter and then the Facet electric pump.
Would the fuel pressure gauge go between the pump and the carb? Can you recommend...
|
Forum: Troubleshooting
04-28-2019, 07:20 PM
|
Replies: 68
Views: 93,045
Ye olde "only runs with the choke out" thread.
After a winter spent rectifying the effects of the boat partner not shutting off the raw water intake when cranking the motor with no start, I finally took the boat out for a sea trial today.
...
|
Forum: General Interest
03-14-2019, 01:55 PM
|
Replies: 5
Views: 2,098
|
Forum: General Interest
03-11-2019, 06:18 PM
|
Replies: 5
Views: 2,098
|
Forum: Wanted to Buy - Engines and Engine Parts
05-13-2017, 05:54 PM
|
Replies: 33
Views: 6,289
|
Forum: General Interest
05-07-2017, 03:21 PM
|
Replies: 3
Views: 2,268
|
Forum: Cooling System
07-10-2016, 01:48 PM
|
Replies: 18
Views: 5,860
The light bulb just went off for me! I had not...
The light bulb just went off for me! I had not completely grasped that a restriction was actually required when using a single stage thermostat. I will now prioritize installing a ball valve. ...
|
Forum: Cooling System
07-09-2016, 05:45 PM
|
Replies: 18
Views: 5,860
|
Forum: Cooling System
07-06-2016, 01:09 AM
|
Replies: 18
Views: 5,860
Thermostat ID question.
Ericson 29.
I've been overheating at RPMs over about 1400 or so. Changed impellers (FWC) but haven't gone any further.
I decided to open the thermostat housing and found a 1/4" spacer under...
|
Forum: Fuel System
07-04-2016, 10:34 AM
|
Replies: 12
Views: 5,925
|
Forum: Fuel System
07-03-2016, 01:22 AM
|
Replies: 12
Views: 5,925
First, thanks for all suggestions.
I did...
First, thanks for all suggestions.
I did swap in a new raw water impeller today. The old one was definitely looking tired.
Replaced the plugs and added a dash of Marvel into each cylinder. ...
|
Forum: Fuel System
06-30-2016, 09:33 PM
|
Replies: 12
Views: 5,925
New A4 owner, fuel delivery problem?
Hello. I've done a fair bit of reading here and on the Moyer site regarding fuel delivery problems. I have some ideas about where I should go but thought I would throw out a query.
-Late model...
|