Return to the home page...
Moyer Marine Atomic 4 Community - Home of the Afourians
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
FAQ
Members List
Search
Today's Posts
Mark Forums Read
Showing results 1 to 11 of 11
Search took
0.01
seconds.
Search:
Posts Made By:
b.johnston
Forum:
Electrical
04-22-2014, 08:19 PM
Replies:
22
Can batteries be placed in lazarette?
Views:
7,594
Posted By
b.johnston
Perception is an issue ;-)
For those who remember last falls infamous p-trap wet section, you have seen the area I'm thinking of dropping the start battery, in the lazarette about a foot and a half from the alternator so...
Forum:
Electrical
04-21-2014, 10:47 PM
Replies:
22
Can batteries be placed in lazarette?
Views:
7,594
Posted By
b.johnston
What discouraged you from this re-location?
What discouraged you from this re-location?
C&C's had batteries located both in the 34' (hundreds built) style under the quarter berth and in the engine compartment ala 27's (near a thousand...
Forum:
Exhaust System
10-27-2013, 09:20 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
Standpipe vs. Waterlift
What would the noise implications be if the water lift were phased out of the system?
The current setup after the water lift rises a good 2 feet above the waterline then exits (still above the...
Forum:
Exhaust System
10-21-2013, 08:53 PM
Replies:
24
Sticky:
Exhaust wrap kit
Views:
28,794
Posted By
b.johnston
From Canada Eh!
When I rebuilt my hot section this week I used MASTERS® METALLIC COMPOUND by G. F. Thompson Co. Ltd., Newmarket, Ontario, Canada...
Forum:
Exhaust System
10-21-2013, 07:54 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
And now for the rest of the Story
It's taken a bit to get it all done but here's what I came up with.
http://www3.sympatico.ca/b.johnston/images/ExhHot.jpg
Now a further question is it normal for the pre through hull tube to...
Forum:
Exhaust System
09-27-2013, 12:32 AM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
Idling while the sails pull
Shawn,
Thank you, I was following you on the idling out of gear to keep the water out.
(edit if the wind dies I did see 6.5 on the knot meter at what didn't sound like anywhere near 3000...
Forum:
Exhaust System
09-26-2013, 10:54 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
Dividing 1 90 in half
Thats really out of the box thinking!
I hope I have enough space (flange to muffler) to try this.
I'll mull it over as we idle back home (plenty of fuel @ 1 gph)
Bruce
Forum:
Exhaust System
09-26-2013, 10:10 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
A lot to catch up on.
Thank you all there are a couple things I didn't think of here.
Jeff I think it could be turned end for end but I'm not sure the height of the vacuum break would be high enough.
Just to clarify...
Forum:
Exhaust System
09-26-2013, 08:06 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
Will tread lightly
Mo & SAStanley,
Thank you I'll be sure to start with raw water off then open when running.
Unfortunately I can't put off the transit.
I hope to have a broad reach on the way home as...
Forum:
Exhaust System
09-26-2013, 05:08 PM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
email not visible to me
Sorry Al your email is not visible to me (either in this thread or the member profile)
I have generated a new link. Is the post photo visible now?
Forum:
Exhaust System
09-26-2013, 09:51 AM
Replies:
35
Is my hot section relly built upside down here?
Views:
10,540
Posted By
b.johnston
Is my hot section really built upside down here?
A few questions so I don't make a costly mistake.
I've just purchased my first boat C&C34 which luckily has a Moyer rebuilt A4 in it. (SN 201171)
I'm taking her to my home port of Hamilton from...
Showing results 1 to 11 of 11
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Announcements
Introductions
Drawings and Schematics
Testing Protocols
Discussion Topics
General Interest
Polls
Helpful Videos
ABYC and USCG Standards
Troubleshooting
General Maintenance
Ignition System
Electrical
Fuel System
Cooling System
Reversing Gear
Exhaust System
Drive Train / Propellers
Overhaul
Safety
Aftermarket Kits and Accessories
Specialty Tools
Moyer Marine Pin-Up's
Good Guys
Links of Particular Interest
The Wish List
Owner Discussion Groups
Discussion Groups
Alberg
Bristol
C&C
Cal
Catalina
Columbia
Dyer Glamour Girl
Ericson
Grampian
Herreshoff
Irwin
Islander
Morgan
Newport
O'Day
Pearson
Ranger
Sabre
Tartan
Off-Topic
General Discussion (Off-Topic)
Boat Construction/Repair
Captain's Confession
Weather
Marine Electronics / Interfacing and Integration
iPad/Tablet/Laptop Applications on the Water
Classified Ads
For Sale - Engines and Engine Parts
For Sale - Other Items
Wanted to Buy - Engines and Engine Parts
Wanted to Buy - Other items
Tools wanted or offered to rent
All times are GMT -4. The time now is
12:43 AM
.
Moyer Marine Inc.
-
Archive
-
Top
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved