Forum: Fuel System
02-06-2016, 09:15 AM
|
Replies: 8
Views: 4,118
|
Forum: Wanted to Buy - Other items
01-17-2016, 07:41 PM
|
Replies: 0
Views: 5,617
|
Forum: Fuel System
10-02-2015, 06:50 AM
|
Replies: 11
Views: 7,893
in line filter
I switched my in line filter from before pump to after and then to carb.
Also moved electric fuel pump to bulkhead.
|
Forum: Troubleshooting
07-17-2015, 05:28 AM
|
Replies: 18
Views: 5,683
|
Forum: Troubleshooting
05-19-2015, 10:59 PM
|
Replies: 30
Views: 24,427
|
Forum: Troubleshooting
05-19-2015, 07:38 AM
|
Replies: 30
Views: 24,427
|
Forum: Cooling System
11-06-2014, 07:05 AM
|
Replies: 29
Views: 7,686
|
Forum: Ignition System
08-10-2014, 06:52 PM
|
Replies: 8
Views: 3,686
|
Forum: Troubleshooting
08-01-2014, 04:30 PM
|
Replies: 30
Views: 9,038
I changed oil today, Rotella 15 w 40.
Removed...
I changed oil today, Rotella 15 w 40.
Removed needle valve and spring on oil pressure regulator.
Cleaned and re-installed .
Adjusted to 42 PSI at 1800 RPM ,water temp 160.
I assuming all is well...
|
Forum: Troubleshooting
07-31-2014, 07:19 PM
|
Replies: 30
Views: 9,038
|
Forum: Troubleshooting
07-31-2014, 06:47 PM
|
Replies: 30
Views: 9,038
|
Forum: Troubleshooting
07-31-2014, 06:36 PM
|
Replies: 30
Views: 9,038
|
Forum: Troubleshooting
07-31-2014, 04:48 PM
|
Replies: 30
Views: 9,038
|
Forum: Troubleshooting
07-26-2014, 05:46 AM
|
Replies: 25
Views: 10,729
|
Forum: Drive Train / Propellers
07-26-2014, 05:33 AM
|
Replies: 34
Views: 13,010
|
Forum: Troubleshooting
07-19-2014, 06:11 AM
|
Replies: 7
Views: 3,844
|
Forum: Drive Train / Propellers
07-18-2014, 05:45 AM
|
Replies: 10
Views: 3,854
I hauled boat the other day to adjust pitch to...
I hauled boat the other day to adjust pitch to allow for a higher RPM.
Prior to adjustment I could only get 1600 RPM and had problems with fouling plugs.
Decreased pitch and took out for a motor....
|
Forum: Drive Train / Propellers
07-16-2014, 05:53 AM
|
Replies: 10
Views: 3,854
Kiwi Prop
I have a 3 blade Kiwi feathering prop and manufacturer recommends sailing in neutral.
I'm not sure if this is the best for engine or prop and usually leave in forward.
I race a lot and hope non...
|
Forum: Drive Train / Propellers
03-20-2014, 09:02 PM
|
Replies: 34
Views: 9,847
Dave
He currently has a large three bladed kiwi...
Dave
He currently has a large three bladed kiwi feathering prop which has been giving us problems when going into reverse.Engine stalls almost immediately when going into reverse.
The martec is the...
|
Forum: Drive Train / Propellers
03-20-2014, 06:14 PM
|
Replies: 34
Views: 9,847
Prop Size
I have a Ranger 30,Atomic 4 Direct Drive and turning a Martec 12 X 6 folding prop.
I am also working on a C&C 34, Atomic 4 with reduction gear and owner has a Martec Eliptec RH 16D X 10P -3 folding...
|
Forum: Safety
03-06-2014, 01:07 PM
|
Replies: 25
Views: 18,639
Racing
One nice thing about racing alot you really begin to watch sail tell tales .
Over the years and most of it racing ,sun screen,sun glasses and no hat has been the normal.
Now if this cold air goes...
|
Forum: General Interest
01-15-2014, 10:05 AM
|
Replies: 33
Views: 7,277
Mmo
Hi Mo
Went to partsource store here in Windsor and counter staff stated we would probably never see it in our area.
Too Bad .
|
Forum: General Interest
11-12-2013, 06:01 PM
|
Replies: 107
Views: 27,475
instruments
Looking to replace speed and depth sounders on two boats.
Trying to find used ones ,display and transducers.
Any out there?
Both A4"s runnimg great
|
Forum: Safety
10-17-2013, 06:55 AM
|
Replies: 36
Views: 30,068
|
Forum: Troubleshooting
08-27-2013, 12:22 PM
|
Replies: 23
Views: 10,786
Pulled plugs this morning,one was...
Pulled plugs this morning,one was damaged,replaced all 4 with Champion RJ8C.Adjusted idle jet out to 2 full turns.
In neutral motor will ramp up easily and back to idle with no hesitation.
In...
|