Forum: Troubleshooting
10-19-2021, 07:01 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-19-2021, 06:31 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-19-2021, 09:27 AM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-19-2021, 08:47 AM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-18-2021, 08:02 PM
|
Replies: 55
Views: 6,918
no good deed goes unpunished
The last time I left you I had achieved 4.7 kts SOG both directions along the fairway in the marina @ 1250rpm.
I decided to replace the exhaust since the hose was original and soft. I thought...
|
Forum: Troubleshooting
10-11-2021, 05:07 AM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-10-2021, 06:39 PM
|
Replies: 55
Views: 6,918
Last week during troubleshooting I pulled the...
Last week during troubleshooting I pulled the exhaust off of the manifold and ran it. No change in performance.
I took the boat for a spin this afternoon I achieved 4.7 kts SOG both directions...
|
Forum: Troubleshooting
10-09-2021, 07:19 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 05:15 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 04:15 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 04:05 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 03:11 PM
|
Replies: 55
Views: 6,918
!!!!!!!!!!!!!!!!!!!BRAND NEW...
!!!!!!!!!!!!!!!!!!!BRAND NEW DEVELOPMENT!!!!!!!!!!!!!!!!!!!!!
After I put the ignition system back together I started the motor and ran her in gear at full throttle. Same top shaft speed of...
|
Forum: Troubleshooting
10-09-2021, 02:20 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 02:09 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 01:37 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 11:26 AM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 11:19 AM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-09-2021, 11:16 AM
|
Replies: 55
Views: 6,918
Ok.
In neutral @800rpm: vacuum is running...
Ok.
In neutral @800rpm: vacuum is running about 13inHg (oscillating wildly between 10 and 17inHg)
On snap accel/decel: bogs down to 1inHg and snaps back to 19inHg then settles back at previously...
|
Forum: Troubleshooting
10-09-2021, 10:19 AM
|
Replies: 55
Views: 6,918
Although not ideal, I hooked up a pressure gage...
Although not ideal, I hooked up a pressure gage to the discharge of the Facet pump and energized it…5#. A little high, but it’s not tee’d in with the carb hooked up. I’m gonna call fuel pressure good.
|
Forum: Troubleshooting
10-09-2021, 09:06 AM
|
Replies: 55
Views: 6,918
I’m at the boat now. I reinstalled the exhaust...
I’m at the boat now. I reinstalled the exhaust last night so I can run the engine for vacuum troubleshooting.
This morning I pulled the carb to look for the Stevedore destructor at the urging of...
|
Forum: Troubleshooting
10-07-2021, 10:07 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-07-2021, 07:14 PM
|
Replies: 55
Views: 6,918
|
Forum: Troubleshooting
10-07-2021, 04:45 PM
|
Replies: 55
Views: 6,918
Tom,
Thank you for your generous offer to...
Tom,
Thank you for your generous offer to pay postage to inspect my prop. I don't believe the prop was the issue with poor forward speed as much as a tired engine. Although compression is good...
|
Forum: Troubleshooting
10-05-2021, 08:49 PM
|
Replies: 55
Views: 6,918
Tom,
I would like to point out that I said...
Tom,
I would like to point out that I said "...I'm the only person alive who hates the Indigo prop". Everyone, and I do mean everyone gushes about their experiences, that's why I bought it.
...
|
Forum: Troubleshooting
10-05-2021, 05:29 PM
|
Replies: 55
Views: 6,918
Joe, Dave, John,
that is my prop...three blade...
Joe, Dave, John,
that is my prop...three blade feathering. I'm fairly certain the strobe-tach is working, but regardless, the engine just barely rises off of high idle speed and maxes out there....
|