Forum: Introductions
10-17-2011, 04:49 PM
|
Replies: 9
Views: 8,040
This thread has some good discussion on...
This thread has some good discussion on standpipes. MM offers a new version of the old Tartan standpipe exhaust system. I think it's superior to the waterlift due the fact that it makes it...
|
Forum: General Interest
11-22-2010, 11:02 PM
|
Replies: 2
Views: 3,153
I would add this as a suggestion to the...
I would add this as a suggestion to the winterising process. Make up a CLEAR hose with a garden hose attachement for your atifreeze take up hose. Then you can see when all the antifreeze is in the...
|
Forum: Cooling System
10-24-2010, 07:51 PM
|
Replies: 19
Views: 5,847
Well I removed the check vavle from the bypass...
Well I removed the check vavle from the bypass system this morning and motored out for a couple of hours today. The temperature gauge sat right under 140 the whole time. It idles down nicely and...
|
Forum: Cooling System
10-23-2010, 09:19 PM
|
Replies: 19
Views: 5,847
Hanley,
I think you are right. With the...
Hanley,
I think you are right. With the addition of the hard angle of the new brass fitting, the check valve and the 1/4 opening in the ball valve, the water is restricted enough that it pushes...
|
Forum: Cooling System
10-23-2010, 08:55 PM
|
Replies: 19
Views: 5,847
|
Forum: Polls
10-22-2010, 08:50 PM
|
Replies: 75
Views: 52,471
All I have at the moment is an ammeter, a...
All I have at the moment is an ammeter, a questionable water temp. gauge and a busted fuel gauge. The birch dowel will not work on my boat. Fill hose is too long and curved.
So....not being an...
|
Forum: Cooling System
10-22-2010, 08:35 PM
|
Replies: 19
Views: 5,847
|
Forum: Cooling System
10-22-2010, 08:14 PM
|
Replies: 19
Views: 5,847
John,
I will remove the sending unit in the...
John,
I will remove the sending unit in the morning and try to clean in there as much as I can but the nipple idea sounds promising. As far as I can tell, the engine just won't warm up to...
|
Forum: Cooling System
10-22-2010, 02:10 PM
|
Replies: 19
Views: 5,847
This is a raw water cooled system. Now that I...
This is a raw water cooled system. Now that I read a little more, I think that maybe the sending unit itself may be blocked. When I cleaned out the gunk under the thermostat housing I may have...
|
Forum: Cooling System
10-22-2010, 11:48 AM
|
Replies: 19
Views: 5,847
cant' get up to operating temp.!!
I can't get up to operiting temperature.
I can only get to about 80 degrees. My first thought was that my gauge was bad but after I shut down it climbs to 140., of course there is no cooling...
|
Forum: Exhaust System
10-13-2010, 10:17 PM
|
Replies: 50
Views: 21,342
|
Forum: Exhaust System
10-13-2010, 09:49 PM
|
Replies: 50
Views: 21,342
Neil,
look at the green piece of metal...
Neil,
look at the green piece of metal bolted to the flange on the motor side of the standpipe. The other end is bolted to the back of the motor I believe to one of the transmission cover bolts. ...
|
Forum: General Maintenance
10-13-2010, 09:28 PM
|
Replies: 2
Views: 2,937
De-greaser and Naval jelly bad for builge?
I would like to get rid of the surface rust and grease build up on my block but I worry that the excess run off of de-greaser my accumulate in the bilge and be a problem. That stuff is highly...
|
Forum: Exhaust System
10-13-2010, 09:04 PM
|
Replies: 50
Views: 21,342
Neil, after looking at your diagram of a...
Neil, after looking at your diagram of a standpipe exhaust and reading more about it, I think I have the original set-up still on my Newport 30. What you described in your previous post sounds a...
|
Forum: Exhaust System
10-10-2010, 10:47 PM
|
Replies: 50
Views: 21,342
Got it! Thanks Neil.
Any atomic-4 specific...
Got it! Thanks Neil.
Any atomic-4 specific design info or equipment would be on my "next purchase" list. Any of you engineer/entrepreneur types out there are greatly appreciated. This back...
|
Forum: Exhaust System
10-10-2010, 10:26 PM
|
Replies: 50
Views: 21,342
|
Forum: Exhaust System
10-10-2010, 10:07 PM
|
Replies: 50
Views: 21,342
Jerry you have me thinking. I can run the raw...
Jerry you have me thinking. I can run the raw water hose through the bulkhead into the quarter berth, install a valve then return the hose into the engine compartment and into the strainer. That...
|
Forum: Exhaust System
10-10-2010, 09:37 PM
|
Replies: 50
Views: 21,342
Hanley: The exhaust still batches the water as...
Hanley: The exhaust still batches the water as it exits the transom but only at idle. It sprays when RPMs are higher. Also, are you speaking of a vented loop in the exhaust hose or in the water...
|
Forum: Exhaust System
10-10-2010, 07:35 PM
|
Replies: 50
Views: 21,342
And yes Niel, I crossed out the name of the...
And yes Niel, I crossed out the name of the muffler that the diagram owner had replaced his with. Mine looks just like the diagram. I also do not have the anti-siphon loop on my water hose leading...
|
Forum: Exhaust System
10-10-2010, 07:21 PM
|
Replies: 50
Views: 21,342
|
Forum: Exhaust System
10-09-2010, 10:47 PM
|
Replies: 50
Views: 21,342
no more fouled plugs
I recently acquired a 74 Newport 30. The original owner kept the boat pretty much as it came from the factory down to the vintage avocado cushions and yellow bubble glass sliders on the galley...
|