Forum: Overhaul
12-03-2020, 12:03 AM
|
Replies: 26
Views: 8,483
saving oldstuff
I was cleaning out my garage. And I’ve got a lot of miscellaneous atomic for stuff. Anybody needs anything let me know and if I’ve got it it’s yours for shipping. Merry Christmas
|
Forum: For Sale - Engines and Engine Parts
11-29-2017, 11:02 PM
|
Replies: 11
Views: 2,683
|
Forum: For Sale - Engines and Engine Parts
12-06-2015, 08:58 PM
|
Replies: 2
Views: 2,768
A-4 parts for sale
I have a block ,cylinder head and manifold ,oil pan ,lots and lots of parts .make me an offer .one part or the whole caboodle ,! Located Portland Oregon fresh water paragon trans available
|
Forum: Troubleshooting
08-18-2013, 12:35 PM
|
Replies: 16
Views: 5,447
Take a deep breath
Start by reading the a- 4 bible under does not run . Now the. Pull your plugs keep track of the firing order . Look at the plugs wet? No ? Great , if wet set aside in the sun or get fresh plugs s ...
|
Forum: Troubleshooting
09-22-2011, 08:44 PM
|
Replies: 5
Views: 2,971
|
Forum: Fuel System
03-21-2011, 03:51 PM
|
Replies: 4
Views: 2,459
jusat a thought
be sure and check the fuel tank overflow and vent screen .Is it facing up and catching rain water? I speak from experience. fair winds adab
|
Forum: Reversing Gear
03-21-2011, 03:46 PM
|
Replies: 8
Views: 6,426
just a thought
Have you considered just removing the complete trans and housing ?
|
Forum: General Interest
03-04-2011, 07:41 PM
|
Replies: 12
Views: 3,578
query
did it work before?
|
Forum: Polls
12-08-2009, 12:27 PM
|
Replies: 84
Views: 67,259
blower
The blower is wired to the engine on switch , a quick look see and sniff and i fire that baby up . fair winds adab1402
|
Forum: Cooling System
10-14-2009, 04:40 PM
|
Replies: 10
Views: 3,425
|
Forum: Fuel System
04-28-2009, 09:55 PM
|
Replies: 3
Views: 3,057
depends
new is always better ,you can make your own gasket out of cardboard or cork ,or simply use a bit of gasket glue permatex
|
Forum: For Sale - Engines and Engine Parts
04-21-2009, 08:12 PM
|
Replies: 3
Views: 3,345
Story of my life
I just installed 4 new mts from west marine 300 bucks, ouch ,if only . good luck on selling those ,im sure a lot of folks could use upgraded mts . fair winds adab1402
|
Forum: Wanted to Buy - Engines and Engine Parts
04-13-2009, 04:07 PM
|
Replies: 1
Views: 2,975
still needed?
75.00 plus shipping ,fresh impellor .Boomdalhank @aol.com
|
Forum: For Sale - Engines and Engine Parts
04-13-2009, 04:06 PM
|
Replies: 0
Views: 2,807
|
Forum: Introductions
04-13-2009, 04:02 PM
|
Replies: 2
Views: 10,338
Welcome aboard matey
a trip to sears for some hi quality tools is in order ,a set of open end box wrenches from 3/8 to 7/8 ,a set of 3 flat blade screw drivers in various sizes ,a set of phillips head drivers ,a set of...
|
Forum: General Maintenance
04-13-2009, 03:51 PM
|
Replies: 3
Views: 4,481
no worries mate
now is the time to get better aquainted with your a-4 .it could be the beginning of a beautiful friendship . Is the impellor due for a change ? if your not sure then it is . order a book and the...
|
Forum: Cooling System
03-23-2009, 06:49 PM
|
Replies: 2
Views: 2,467
|
Forum: Fuel System
03-19-2009, 06:42 PM
|
Replies: 18
Views: 6,213
time waits for no fuel
hi rick gas does break down over time ,i suggest ,if your not sure of its age ,a)take a sample and have it analyzed or my choice B)drain it all out throw it into a rig,car, truck etc and fill the...
|
Forum: Overhaul
03-14-2009, 02:09 PM
|
Replies: 2
Views: 4,593
suggestion
if money were no object i,d spring for a moyer rebuild and save the time and effort of machine shops .replacement and installation can be jobbed out just check around your area for someone with...
|
Forum: Ignition System
03-14-2009, 02:05 PM
|
Replies: 6
Views: 5,288
timing is everything
just a quick thought ,timing is usually set a few degrees after top dead center ,or a few degrees before ,ladies choice . pull your #1 around till its on compression stroke ,pull the plug, stuff a...
|
Forum: Wanted to Buy - Engines and Engine Parts
03-14-2009, 01:56 PM
|
Replies: 2
Views: 3,106
alternator upgrade
just a thought have you considered taking the standard alternator to a reputable shop and having it beefed up ?
|
Forum: Troubleshooting
03-08-2009, 02:11 PM
|
Replies: 15
Views: 5,526
just a thought
you may not be getting the advance you require on acceleration .take a peak at your advance and retard springs inside your distibutor . and if that looks good get a timing light at harbour freight...
|
Forum: General Interest
03-08-2009, 02:04 PM
|
Replies: 13
Views: 4,651
motor mts
or you could spend 3-400.00 at west marine on motor mts it depends on your alignment issues and you vibration comfort level .om my cal 29 i use the mts .fair winds adab1402
|
Forum: General Maintenance
02-28-2009, 02:59 PM
|
Replies: 2
Views: 3,900
|
Forum: Troubleshooting
02-25-2009, 07:36 PM
|
Replies: 15
Views: 5,526
ps
i live in portland as well if you need advice or a hand 360-696-9710 m-f 10-2
|