Forum: Ignition System
10-04-2021, 02:56 PM
|
Replies: 1
Views: 1,556
Distributor stuck, can’t remove it
I am in the process of installing a new water jacket side plate, and had to put in repair studs in most of thee holes. Now in order to slide the plate onto the studs, I need to remove the...
|
Forum: Electrical
10-01-2021, 08:09 PM
|
Replies: 9
Views: 2,000
Thanks for the replies, just had a mechanic...
Thanks for the replies, just had a mechanic friend look at it, turns out it’s not a Balmar, it just was in a Balmar box, it’s a used Motorola 100 amp with internal regulation and could be quite...
|
Forum: Electrical
09-30-2021, 10:59 AM
|
Replies: 9
Views: 2,000
|
Forum: Electrical
09-29-2021, 02:46 PM
|
Replies: 9
Views: 2,000
|
Forum: Overhaul
11-03-2020, 03:01 PM
|
Replies: 5
Views: 962
I may need education on the MMO treatment.
...
I may need education on the MMO treatment.
I do always put some MMO in with the oil and also include a bit in the gas as is recommended somewhere.
The motor start easily and runs well. I ran...
|
Forum: Overhaul
11-03-2020, 02:28 PM
|
Replies: 5
Views: 962
How concerned should I be about low compression
Hi, I have a '73 Ranger 29 with original A4, which became mine in 2005. It was rebuilt in 1989, and a friend did a valve job on it a couple years in 2007 after I had several sticky valve issues...
|
Forum: Overhaul
08-30-2019, 02:11 PM
|
Replies: 2
Views: 1,592
When to rebuild (or replace)
Hi, background, I've had the boat 15 years, had some sticky valve troubles for the first 4 four years until a friend did an in the boat valve job while I was on the hard. Since then the motor has...
|
Forum: Troubleshooting
07-25-2019, 12:33 PM
|
Replies: 2
Views: 2,249
Motor rough and low power in gear
Hi all, last Sunday my motor, which was running fine, suddenly lost power, I tried shifting to neutral then reverse to clear any seaweed on the prop, no difference. It revs fine in neutral but not...
|