Forum: General Interest
07-04-2020, 11:42 AM
|
Replies: 1
Views: 1,017
Shaft coupling question
Hi Folks, the clearances in my prop aperture are such that there is no way to pull the prop without either pulling the rudder, which I am loath to do, or remove the shaft from the coupling and push...
|
Forum: C&C
04-14-2020, 12:22 PM
|
Replies: 2
Views: 12,981
Off topic poll about antifouling coatings
Good Day Folks,
I hope a non engine discussion is OK....but it is about boats.
I'm taking all the coatings off of the bottom of our C&C Corvette and starting over. The last antifouling paint I used...
|
Forum: General Interest
04-14-2020, 11:24 AM
|
Replies: 2
Views: 2,267
Off topic poll about antifouling coatings
Good Day Folks,
I hope a non engine discussion is OK....but it is about boats.
I'm taking all the coatings off of the bottom of our C&C Corvette and starting over. The last antifouling paint I...
|
Forum: For Sale - Other Items
02-12-2020, 09:41 AM
|
Replies: 1
Views: 6,451
|
Forum: Troubleshooting
01-06-2020, 11:25 AM
|
Replies: 90
Views: 38,772
|
Forum: General Maintenance
05-05-2019, 03:00 PM
|
Replies: 2
Views: 2,334
Detergent or Non Detergent Oil
Yesterday I was at the store to get oil for my oil change. I've run straight 30 weight oil for years...but for the life of me I could not recall if I used detergent or non detergent. I guessed non...
|
Forum: General Interest
03-23-2019, 08:02 AM
|
Replies: 4
Views: 2,164
|
Forum: For Sale - Engines and Engine Parts
02-05-2019, 08:10 AM
|
Replies: 0
Views: 1,209
A4 for sale in Stevensville
Hey All, just saw a good looking A4 take out complete for sale with Josh Davidson at Anchors and Oars in Stevensville (Kent Narrows) Maryland. Josh part out boats and resells the good stuff. If...
|
Forum: Ignition System
05-22-2016, 10:01 AM
|
Replies: 10
Views: 3,811
Thanks for all this folks ! The Cole Hersee...
Thanks for all this folks ! The Cole Hersee ignition switch was new last year. One of the first replacement items on this journey to revive this engine...as were most all ignition parts and wiring....
|
Forum: Ignition System
05-21-2016, 12:16 PM
|
Replies: 10
Views: 3,811
|
Forum: Ignition System
05-21-2016, 10:47 AM
|
Replies: 10
Views: 3,811
|
Forum: Ignition System
05-21-2016, 10:04 AM
|
Replies: 10
Views: 3,811
Mysterious and immediate shut down
Good day everyone,
My otherwise fine running engine just stopped the the other day while at the slip getting ready to get underway. No spitter, spatter, sputter....just off.
Turned the key off,...
|
Forum: Polls
03-09-2016, 01:44 PM
|
Replies: 94
Views: 76,456
|
Forum: General Interest
06-21-2015, 01:18 PM
|
Replies: 4
Views: 2,502
Success !!
Well, after over 20 years of sitting on the hard, the little A4 in our C&C Corvette came to life yesterday. WOOOOO HOOOOO !!
Thank you all for your advice and support. I've been lurking on here...
|
Forum: Fuel System
06-18-2015, 06:03 AM
|
Replies: 5
Views: 3,546
|
Forum: Fuel System
06-17-2015, 10:27 AM
|
Replies: 5
Views: 3,546
Gas overflowing into carburetor throat
Hi Folks,
After some reading on the subject I take it that gas overflowing into the throat of the carb is due to the needle valve not seating and shutting off the flow. This could be due to...
|
Forum: Electrical
02-27-2015, 09:42 AM
|
Replies: 4
Views: 2,993
|
Forum: Electrical
02-25-2015, 03:36 PM
|
Replies: 4
Views: 2,993
Wiring 12v meter
Hi All,
I want to install a BlueSea 12v meter to monitor two batteries. I have a basic two battery system with a 1/2/Both/Off selector switch and want to wire the meter through dual pole 3...
|
Forum: Troubleshooting
12-05-2014, 01:59 PM
|
Replies: 7
Views: 4,267
I owned a boat with a P60 in it for many years...
I owned a boat with a P60 in it for many years and the same thing happened to me, and I immediately replaced the same components as you with no luck.
A very knowledgeable friend told me to check one...
|
Forum: Safety
12-01-2014, 01:03 PM
|
Replies: 22
Views: 23,790
|
Forum: Safety
12-01-2014, 12:57 PM
|
Replies: 22
Views: 23,790
Columbia 29
Good Day,
Welcome to the forum. You'll get excellent advice and a lot of help here.
I thought I would send you some information about the Columbia 29 you may find interesting. I'll send it to...
|
Forum: For Sale - Engines and Engine Parts
11-14-2014, 12:54 PM
|
Replies: 3
Views: 3,380
|
Forum: Exhaust System
09-01-2014, 05:16 PM
|
Replies: 25
Views: 11,222
|
Forum: Ignition System
08-28-2014, 09:26 AM
|
Replies: 6
Views: 3,243
I just used this same technique. I took the...
I just used this same technique. I took the gauge fitting off of my compression gauge, and since I didn't have a balloon on board, I cut the finger off a latex glove and taped it to the plug hole...
|
Forum: For Sale - Engines and Engine Parts
08-28-2014, 09:23 AM
|
Replies: 12
Views: 3,379
|