Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 25 of 29
Search took 0.01 seconds.
Search: Posts Made By: SailingReckless
Forum: Troubleshooting 09-29-2019, 06:23 PM
Replies: 16
Views: 7,046
Posted By SailingReckless
I have been torquing according to the pattern....

I have been torquing according to the pattern. I’ve checked the head for warping and if it’s warped at all it would have to be extremely extremely slight. I did just notice a new issue though. I have...
Forum: Troubleshooting 09-16-2019, 04:40 PM
Replies: 16
Views: 7,046
Posted By SailingReckless
Just had a guy on the phone with me and he helped...

Just had a guy on the phone with me and he helped me run everything down and talk thru everything with me. I’m thinking now that it’s possible that I didn’t have the head torqued down properly and...
Forum: Troubleshooting 09-16-2019, 03:33 PM
Replies: 16
Views: 7,046
Posted By SailingReckless
14520 I’m just sitting here watching water leak...

14520
I’m just sitting here watching water leak out of that hole by the stud now for almost an hour?!
Forum: Troubleshooting 09-16-2019, 03:02 PM
Replies: 16
Views: 7,046
Posted By SailingReckless
14518 14519 Here’s where I’m at with this...

14518
14519
Here’s where I’m at with this now....
I got rid of the 30 feet of hose for then raw water intake and came in from the thru hole and right up to the engine. Here’s what with wrong with...
Forum: Troubleshooting 08-19-2019, 10:08 AM
Replies: 16
Views: 7,046
Posted By SailingReckless
This is the newer model engine. I opened up...

This is the newer model engine.
I opened up the water pump and took out the impeller. It looked good and water came out when I opened it up. Then I looked at the hoses leading to the thermostat....
Forum: Troubleshooting 08-18-2019, 12:51 PM
Replies: 16
Views: 7,046
Posted By SailingReckless
I got it started! I reset the distributor in it's...

I got it started! I reset the distributor in it's hole one tooth back and it fired up:D
New problem....first time I started it up the exhaust was spitting out dirty water. I let it run for about 5...
Forum: Troubleshooting 08-18-2019, 11:46 AM
Replies: 16
Views: 7,046
Posted By SailingReckless
Exclamation Won't start at all now!

Long, long list of problems with this boat and engine. Put my boat in the water in May. Got the engine running long enough to get it into my slip. However, it ran horrible and stalled out during the...
Forum: Troubleshooting 08-09-2019, 12:59 AM
Replies: 10
Views: 2,509
Posted By SailingReckless
I disconnected the fuel line from the carburetor...

I disconnected the fuel line from the carburetor and manually pumped out fuel into a jar and it was clean.
Forum: Troubleshooting 08-08-2019, 01:20 PM
Replies: 10
Views: 2,509
Posted By SailingReckless
Exclamation HELP Water in carburetor!

Just took off my carburetor to take it in to have someone look at it and it was full of water! I know the fuel supply from the mechanical fuel pump is good clean fuel. Does that mean that the water...
Forum: Troubleshooting 06-03-2019, 06:44 PM
Replies: 14
Views: 8,281
Posted By SailingReckless
YES raw water cooled

YES raw water cooled
Forum: Troubleshooting 06-03-2019, 11:53 AM
Replies: 14
Views: 8,281
Posted By SailingReckless
junk2MBzWa8https://youtu.be/junk2MBzWa8 ...

junk2MBzWa8https://youtu.be/junk2MBzWa8



Here’s the white smoke from the exhaust. Have not had the time to check the temperature gauge yet. Hopefully this weekend😊
Forum: Troubleshooting 06-03-2019, 11:44 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
I will talk to you before I do anything at all...

I will talk to you before I do anything at all now😊✌🏼
Forum: Troubleshooting 06-03-2019, 11:42 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
YouTube- working on the carburetor

Akvty8qAalo

https://youtu.be/Akvty8qAalo



After I replaced the coil, I took off the carb and cleaned it out, replaced gaskets and put it back on. Thanks again guys!
Now I have new problems...
Forum: Announcements 06-03-2019, 11:37 AM
Replies: 6
Views: 12,479
Posted By SailingReckless
Forum: Troubleshooting 05-27-2019, 07:06 AM
Replies: 14
Views: 8,281
Posted By SailingReckless
The buzzer is buzzing! Is it safe to say that if...

The buzzer is buzzing! Is it safe to say that if the buzzer is buzzing upon start that it will also buzz if temp gets too high?( I think I read over 200)? The oil pressure gauge at the other end is...
Forum: Troubleshooting 05-27-2019, 06:57 AM
Replies: 14
Views: 8,281
Posted By SailingReckless
Leaving the boat this morning but when I come...

Leaving the boat this morning but when I come back in a few days I will post a video. If there was water in the cylinders would that make the oil cloudy or milky? The oil now is very clean and clear....
Forum: Troubleshooting 05-26-2019, 07:28 PM
Replies: 14
Views: 8,281
Posted By SailingReckless
Lots of white smoke out of exhaust!

Engine is starting up great and staying running without stalling out now after I replaced a bad ignition coil this morning! Hurray:D
So much white smoke out of the exhaust though:( I let it run for...
Forum: Troubleshooting 05-26-2019, 11:43 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
14238 Here is a pic of the new coil.

14238

Here is a pic of the new coil.
Forum: Troubleshooting 05-26-2019, 11:17 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
I don't see a brand name on it or the box it came...

I don't see a brand name on it or the box it came in.
The part number is 18-5435. The box reads (has internal resistor) Replaces Crusader 41080. I paid $54.99 at the local marine supply.
Forum: Troubleshooting 05-26-2019, 10:37 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
Yessssss! :D Success! :cool: Spent the night on...

Yessssss! :D Success! :cool: Spent the night on the boat last night. First thing this morning, as soon as the parts store opened, I picked up a new coil. Put it on and........no stalling! :D

Now...
Forum: Troubleshooting 05-25-2019, 02:01 PM
Replies: 29
Views: 14,526
Posted By SailingReckless
Do you say it’s damaged because with the key on...

Do you say it’s damaged because with the key on it’s getting hot?
Forum: Troubleshooting 05-25-2019, 11:14 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
There are two copper fuel lines that I believe...

There are two copper fuel lines that I believe can only be adjusted with crescent wrenches. The nuts on the lines are quite rounded. Hard to get those tightened on. Considering changing over to black...
Forum: Troubleshooting 05-25-2019, 11:08 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
It has the mechanical fuel pump. I took it off...

It has the mechanical fuel pump. I took it off and cleaned everything I could. I did notice a couple things yesterday that I’ll mention even though I have no idea if they relate to this. I had the...
Forum: Troubleshooting 05-25-2019, 09:34 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
Last night I was reading a thread about fuel/air...

Last night I was reading a thread about fuel/air leaks. I would not doubt that I have one or several of these. I have recently figured something out....when something says hand tighten....that is...
Forum: Troubleshooting 05-25-2019, 09:05 AM
Replies: 29
Views: 14,526
Posted By SailingReckless
I watched the video and now know what points are...

I watched the video and now know what points are :cool: but I’m sorry I don’t know if I have the pointless set. I’m not at my boat right now so I can’t look at the model and try to search it. That...
Showing results 1 to 25 of 29

 
Forum Jump

All times are GMT -4. The time now is 03:36 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved