Forum: For Sale - Engines and Engine Parts
11-14-2014, 09:39 AM
|
Replies: 3
Views: 3,380
|
Forum: Cooling System
11-28-2013, 11:40 AM
|
Replies: 30
Views: 18,526
|
Forum: Drive Train / Propellers
05-13-2013, 11:41 AM
|
Replies: 81
Views: 18,619
New Indigo Prop
Have installed the new Indigo 7.7 prop. Better performance than the 7.4
I had on for 7 years. Improved push and less vibration. Hull speed at 1500
rpm. E 27 sailboat.. Very much pleased with...
|
Forum: Troubleshooting
08-08-2012, 11:28 AM
|
Replies: 20
Views: 14,022
|
Forum: Polls
11-15-2011, 11:29 AM
|
Replies: 75
Views: 52,489
Busted fuel guage?
To check on fuel level, try using a studsensor???? I use
this to monitor fuel tank and holding tank.....
|
Forum: General Maintenance
09-03-2011, 12:35 PM
|
Replies: 5
Views: 2,639
Mmi manual
Still available????? Tremchr@comcast.net
|
Forum: Moyer Marine Pin-Up's
08-11-2011, 10:24 AM
|
Replies: 7
Views: 30,513
|
Forum: Cooling System
08-11-2011, 10:10 AM
|
Replies: 31
Views: 26,840
Heat exchanger
The pic on the right, green Atomic 4 is mine. The heat exchanger was built
in Seattle years ago. Not available... Chris
|
Forum: Cooling System
08-11-2011, 10:06 AM
|
Replies: 31
Views: 26,840
FWC Heat Exch.
I have one just like yours... You can replace the end cap with a rubber cap. Easy to take off for cleaning. Bit pricey however......
|
Forum: Troubleshooting
12-11-2010, 12:09 PM
|
Replies: 9
Views: 4,477
Mechanical oil pressure guage
Don sells a mechanical oil pressure guage that connects directly to the oil pressure port. I wonder if this would give a better reading of oil pressure.
Any one have one installed???????
CT
|
Forum: Polls
12-03-2010, 07:31 PM
|
Replies: 61
Views: 44,863
|
Forum: General Interest
11-18-2010, 10:48 AM
|
Replies: 7
Views: 3,472
Hot marina
Has anyone used a voltmeter to test how hot a marina may be?
I'm wondering by grounding the negitive of the meter and dangle over the
side the positive of the meter if this would give a reliable...
|
Forum: Electrical
08-22-2010, 03:55 PM
|
Replies: 3
Views: 2,229
Terminal Fuse Block
Has anyhone insalled a terminal fuse block to the positive of the battery.
size Mas 300 amp buss???
|
Forum: Troubleshooting
07-11-2010, 04:47 PM
|
Replies: 7
Views: 3,457
|
Forum: Troubleshooting
07-11-2010, 04:46 PM
|
Replies: 7
Views: 3,457
|
Forum: Troubleshooting
07-11-2010, 04:46 PM
|
Replies: 7
Views: 3,457
|
Forum: Troubleshooting
07-11-2010, 01:57 PM
|
Replies: 7
Views: 3,457
over heating
My Atomic 4 running at 1200rpm heats up to 190deprees at 35lbs oil pressure.
When I increase the rpms to to 1800 the temp go to 200-210.
Speed increases as well to 5kts. We have good water flow. ...
|
Forum: Announcements
04-23-2010, 09:59 AM
|
Replies: 23
Views: 23,007
|
Forum: Troubleshooting
01-17-2010, 09:25 AM
|
Replies: 2
Views: 2,660
|
Forum: Troubleshooting
01-17-2010, 09:20 AM
|
Replies: 2
Views: 2,660
Spark plug won't fit
Tried to install Autolite 374 spark plugs, on the A4. Won't fit what gives.
C.T
|
Forum: Fuel System
05-18-2009, 12:15 PM
|
Replies: 10
Views: 4,239
Old Fuel
What type of fuel additive should one use to reguvinate old gas?
Thanks, Chris
|
Forum: General Maintenance
02-07-2009, 10:26 AM
|
Replies: 41
Views: 117,315
Use of ZDDP Motor Oil
Don will the use of ZDDP (zinc) Motor Oil be usefull for the A-4 Engine? It is recommended for flat tappet engines.
|
Forum: General Maintenance
10-12-2008, 11:05 AM
|
Replies: 8
Views: 10,903
|
Forum: General Maintenance
10-11-2008, 05:04 PM
|
Replies: 8
Views: 10,903
Grounding Prop Shaft
A friend of mine suggested the following. To ground the prop shaft. connect a gound wire to the engine. Place the wire ever so slightly upon the top of the shaft to avoid scarring the shaft. Thus...
|
Forum: Fuel System
10-09-2008, 11:07 AM
|
Replies: 9
Views: 10,925
Poly propolene Tank
I also have a inoperable gas guage. However I monitor my gas consumption by placing a bright flashlight up aganst the side of the Propolene tank. The bright light is enough to show the level of...
|