Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: TerryB
Forum: Introductions 08-09-2018, 08:47 PM
Replies: 24
Views: 10,987
Posted By TerryB
Coil Wiring

Don, the way I have the coil wired now is three wires to the positive terminal of the coil. They come from the ignition switch, the distributor and the alternator. The only wire in the negative side...
Forum: Introductions 08-09-2018, 07:54 AM
Replies: 24
Views: 10,987
Posted By TerryB
Solved

Well it took me awhile to figure this out but I was able to resolve all my engine woes. The boat was new to me and the initial problem was overheating. In summary I replaced the impeller, cooling...
Forum: Introductions 07-22-2018, 01:59 PM
Replies: 24
Views: 10,987
Posted By TerryB
Won’t start

So I tested voltage tp the coil and it was fine. There was spark from coil wire, from the spark plug #1 as well. I looked at gas vent, it was okay. There was fuel leading up to carb and manual pump...
Forum: Introductions 07-20-2018, 12:44 PM
Replies: 24
Views: 10,987
Posted By TerryB
Coil

From MMI. 3.4 ohms resistance. I’m wondering if I blew a fuse. I read there is a 20 amp fuse somewhere from the starter to the coil
Forum: Introductions 07-19-2018, 05:40 PM
Replies: 24
Views: 10,987
Posted By TerryB
Won’t start

Well changed coil. Turns over but won’t start. Was running fine. Lots of gas.
Forum: Introductions 07-12-2018, 08:10 PM
Replies: 24
Views: 10,987
Posted By TerryB
Coil

I will take it off tomorrow as it was too hot to touch and I was fed up and needed a beer lol. I just bought the boat and the learning curve is steep. Do coils need a resister?

I’m not even sure...
Forum: Introductions 07-12-2018, 08:01 PM
Replies: 24
Views: 10,987
Posted By TerryB
Update 2

Well a little progress today. Then slapped back down to reality. I replaced the exhaust hose with a new one. I checked the impeller for dimples, there were none and te new one I put n a month ago is...
Forum: Introductions 07-11-2018, 09:54 PM
Replies: 24
Views: 10,987
Posted By TerryB
Update

Thank you all for your input. So I flushed engine with two gallons of muriatic acid. First flush let soak for 15 minutes and then repeated before flushing with sea water. There were lots of brown...
Forum: Introductions 07-03-2018, 08:35 PM
Replies: 24
Views: 10,987
Posted By TerryB
New guy

Hi,

I have a 1976 C&C 27 with a late model A4. The motor has rwc and been run in salt water most of her life. I launched her last month and the distributor disintegrated. I was able to remove...
Showing results 1 to 9 of 9

 
Forum Jump

All times are GMT -4. The time now is 03:50 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved