Forum: Troubleshooting
08-13-2023, 11:29 AM
|
|
Replies: 4
Views: 707
|
|
Forum: Troubleshooting
08-13-2023, 08:42 AM
|
|
Replies: 4
Views: 707
Stalling
In the water last week. Engine started easily and ran for 45 min from marina to my mooring. A few days later went to start it. Engine will catch quickly with choke, run from 10 to 30 seconds but...
|
|
Forum: Troubleshooting
08-06-2022, 01:50 PM
|
|
Replies: 3
Views: 1,157
No compression
Engine won’t start after three years out of water(couldn’t get to Canada due to covid). Mechanic says poor compression. Stuck valves or rings. Can valves be accessed to free them by removing...
|
|
Forum: Ignition System
08-16-2019, 02:58 PM
|
|
Replies: 9
Views: 3,169
|
|
Forum: Ignition System
08-16-2019, 06:26 AM
|
|
Replies: 9
Views: 3,169
|
|
Forum: Ignition System
08-15-2019, 08:06 PM
|
|
Replies: 9
Views: 3,169
Carbon Fiber plug wires
My engine was rebuilt here in Nova Scotia and came back with new plug wires. Are the new carbon fiber wires compatible with A4 ignition system?
|
|
Forum: Troubleshooting
09-09-2018, 01:13 PM
|
|
Replies: 12
Views: 3,103
|
|
Forum: Troubleshooting
09-09-2018, 11:45 AM
|
|
Replies: 12
Views: 3,103
|
|
Forum: Troubleshooting
09-09-2018, 07:13 AM
|
|
Replies: 12
Views: 3,103
Changed oil a couple of times with oil getting...
Changed oil a couple of times with oil getting clear. Still no compression on cylinders 1, 2, 3. I figure I'm looking at an engine teardown/rebuild. Much as I would like to use Moyer Marine, the...
|
|
Forum: Troubleshooting
09-07-2018, 01:07 PM
|
|
Replies: 12
Views: 3,103
|
|
Forum: Troubleshooting
09-07-2018, 06:27 AM
|
|
Replies: 12
Views: 3,103
|
|
Forum: Troubleshooting
09-06-2018, 09:07 PM
|
|
Replies: 12
Views: 3,103
|
|
Forum: Troubleshooting
09-06-2018, 01:58 PM
|
|
Replies: 12
Views: 3,103
help with compression
Engine won't start, of course. i probably cranked it too long with water intake open. When I check compression, no compression on cylinders 1 and2, a trace in cylinder 3, and good compression in 4...
|
|
Forum: Fuel System
08-17-2018, 10:07 AM
|
|
Replies: 5
Views: 4,730
|
|
Forum: Fuel System
08-16-2018, 08:59 AM
|
|
Replies: 5
Views: 4,730
float needle sticking
engine will start for a few seconds, die, and then not restart. I have carburetor apart, and needle valve seems to be sticking in closed position and not dropping down with gravity. Could this be...
|
|
Forum: Troubleshooting
08-20-2017, 07:32 PM
|
|
Replies: 6
Views: 2,296
|
|
Forum: Troubleshooting
08-16-2017, 10:19 AM
|
|
Replies: 6
Views: 2,296
boat just went in the water. Battery several...
boat just went in the water. Battery several years old but not sure exactly. Battery voltage across posts dropped from 11.8 to 2.3 after 10 seconds slow reluctant crank. Got to be bad battery.
|
|
Forum: Troubleshooting
08-15-2017, 03:57 PM
|
|
Replies: 6
Views: 2,296
starter barely cranks
Need advice. With battery just charged and functional(according to marina manager), when I go to start the engine, it barely cranks for 10-15 seconds, and then won't turn over at all. I have...
|
|
Forum: Fuel System
08-11-2016, 05:14 PM
|
|
Replies: 3
Views: 1,903
|
|
Forum: Troubleshooting
08-19-2014, 09:33 AM
|
|
Replies: 4
Views: 2,696
no spark
boat went in the water yesterday, and engine won't catch. no spark when I move the wire supplying the distributor near the block and crank it. I took apart the distributor, sanded the points, and...
|
|
Forum: Fuel System
10-02-2011, 09:30 AM
|
|
Replies: 11
Views: 8,439
fuel hose size and fittings
Don:
I'm planning to install a Racor filter. What size fittings should I get for the input and output lines? I know that the threaded fittings are 1/4 inch NPT, but don't know the diameter of...
|
|
Forum: C&C
08-29-2011, 07:51 PM
|
|
Replies: 1
Views: 7,668
Redwing 30 fuel filter
I'm thinking of putting a fuel filter in. Can any Redwing owner advise me on where to mount it.
|
|
Forum: Fuel System
06-23-2010, 09:29 AM
|
|
Replies: 8
Views: 11,324
rebuild
I recently rebuilt the carburetor, using Moyer Marine rebuild kit. Took maybe 1 1/2 hours. Good diagrams with kit. Only recommendation is to be sure to have some small screwdrivers to get jets out.
|
|
Forum: Fuel System
06-16-2010, 10:29 AM
|
|
Replies: 13
Views: 10,320
|
|
Forum: Fuel System
04-11-2010, 11:11 PM
|
|
Replies: 2
Views: 2,186
|
