Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 25 of 255
Search took 0.01 seconds.
Search: Posts Made By: azazzera
Forum: Fuel System 07-01-2021, 09:13 PM
Replies: 2
Views: 958
Posted By azazzera
Smarter every day

I will assume due to the vast interests and inquisitiveness of all the participants on this site most may know and have already seen this video, or one like it. The “Smarter Every Day “ YouTube...
Forum: Electrical 06-21-2021, 12:23 PM
Replies: 8
Views: 1,615
Posted By azazzera
After trying to methodically trouble shoot the...

After trying to methodically trouble shoot the problem I believe I have found the connection that is causing the low voltage. Thank you for all the help.
Forum: Electrical 06-15-2021, 06:31 PM
Replies: 8
Views: 1,615
Posted By azazzera
A bit more information on how I took the voltage...

A bit more information on how I took the voltage measurements. There were small alligator clips at the end of the jumper wire that I could clip on to the spade connectors. The positive probe of the...
Forum: Electrical 06-15-2021, 06:03 PM
Replies: 8
Views: 1,615
Posted By azazzera
Was back on the boat this morning. Connected the...

Was back on the boat this morning. Connected the radio and pressed the power button and it magically turned on. Cycled it on and off a few times and no problems. I connected the same jumper wires I...
Forum: Electrical 06-13-2021, 05:22 AM
Replies: 8
Views: 1,615
Posted By azazzera
Thanks for the reply. I had an inkling that could...

Thanks for the reply. I had an inkling that could be. I replaced the connectors at the radio end. Still one more spade set I can examine/replace. Next chance I get on the boat I’ll look at that and...
Forum: Electrical 06-12-2021, 10:58 AM
Replies: 8
Views: 1,615
Posted By azazzera
not engine question but still need help

my standard horizon explorer gx1700 radio will not turn on. worked fine up to this season. on own circuit with breaker. fused. when line tested it reads 12.2-12.8 volts. I attached unit direct to...
Forum: General Interest 05-31-2020, 02:35 PM
Replies: 12
Views: 1,858
Posted By azazzera
Names to wifi

Not at all engine related but respect opinions on this sight. I have a simrad 32 tiller pilot on a pearson30. Would like to use iNavX with it. Having very limited knowledge about electronics I am...
Forum: Troubleshooting 06-15-2019, 09:08 AM
Replies: 5
Views: 3,608
Posted By azazzera
For the raw water side. I forget what direction...

For the raw water side. I forget what direction it will turn but that will determine what side is in and out. My pump is mounted off of the flywheel end.
Forum: Troubleshooting 06-15-2019, 08:54 AM
Replies: 5
Views: 3,608
Posted By azazzera
The type of heat exchanger you have is hung...

The type of heat exchanger you have is hung horizontally. It looks like it has markings for how the hoses hook up. If not my suggestion is to pour some water in the cap and see were it exits. That...
Forum: Ericson 12-08-2018, 02:43 PM
Replies: 237
Views: 104,430
Posted By azazzera
ss from lowes

my local lowes store didn't know the stainless alloy that was used in there hardware. My local west marine had no idea either. May get corrosion sooner than you think. I've had good luck with Bolt...
Forum: General Interest 11-28-2018, 06:52 AM
Replies: 13
Views: 2,784
Posted By azazzera
Not building it myself. Cardboard boxes only...

Not building it myself. Cardboard boxes only mock-ups to see what will fit in my space. Plan on getting tank from one of online stores. Plastic mart. Tank depot. Etc. I assume no baffling because...
Forum: General Interest 11-27-2018, 03:00 PM
Replies: 13
Views: 2,784
Posted By azazzera
Need collective wisdom

I’m installing a water tank under v-birth. Want to know if one demention of tank is better over another. I’ve decided on one of two tanks that will fit in the space I have. My question, is one of...
Forum: Overhaul 10-12-2018, 10:58 AM
Replies: 10
Views: 2,856
Posted By azazzera
Would be very interested if Mr. Fenner could...

Would be very interested if Mr. Fenner could reserect it. Don’t know anything about the geometry of the welds that would have to occur but have been absolutely mesmerized by his abilities. If anyone...
Forum: Overhaul 10-11-2018, 10:15 PM
Replies: 10
Views: 2,856
Posted By azazzera
I just wanted to comment on the very liberal use...

I just wanted to comment on the very liberal use of the term “hairline cracks”. That’s more like a head of hair-line crack.
Forum: Cooling System 09-26-2018, 02:55 PM
Replies: 11
Views: 3,700
Posted By azazzera
Very informative

I don’t ever remember reading about that on any of these threads. Intersting. I wonder the amount of time people are trying to chase down water in the oil that it turns out to be this problem. Do you...
Forum: Cooling System 09-26-2018, 08:01 AM
Replies: 11
Views: 3,700
Posted By azazzera
Don. Can you explain further about this. I...

Don.
Can you explain further about this. I have never heard about this before. When you say it was a “flaw”, dose that mean a thin spot in the castings that tends to leak there or is it a designed...
Forum: Cooling System 09-25-2018, 03:57 PM
Replies: 11
Views: 3,700
Posted By azazzera
I dont remember a factory plug being in that...

I dont remember a factory plug being in that location. I think that Don was talking about a flaw to an area of the block that should be solid steel. the fix is to turn the flaw into a threaded hole...
Forum: General Interest 09-22-2018, 09:24 PM
Replies: 21
Views: 5,490
Posted By azazzera
Flashback

Reading your account of your trip brought me back to when I took my trip out of mt. Sinai harbor to port Jeff. My sister came along and very glad I had the extra pair of hands. It must have been 15...
Forum: General Interest 09-12-2018, 01:56 PM
Replies: 21
Views: 5,490
Posted By azazzera
Soooo..... ya. Gas leak should be your major...

Soooo..... ya. Gas leak should be your major concern. Then with all that corrosion what is your through Hull raw water valve like. I have a 1972/3 p30 and have a cone type valve. Mine was frozen...
Forum: General Interest 08-31-2018, 08:53 PM
Replies: 5
Views: 2,030
Posted By azazzera
Don’t know if they may have what you are looking...

Don’t know if they may have what you are looking for but they have a lot

Bolt depot.com
Forum: Ignition System 08-25-2018, 08:49 AM
Replies: 5
Views: 2,395
Posted By azazzera
Proper probe use.

I'll do some searching on the web but I thought it might be helpful to have a discution about how to use the meter specifically how to place the probes. I have always held the thought that if you...
Forum: Ignition System 08-24-2018, 07:16 PM
Replies: 5
Views: 2,395
Posted By azazzera
Analyzing the data.

Just took some ohm and voltage reading today trying to analyze coil. Now I'm sure I'm missing some large factors in order to get a full picture of ignition system but I hope some conclusions can be...
Forum: Ignition System 08-18-2018, 09:37 AM
Replies: 11
Views: 3,483
Posted By azazzera
thank you all. I do deeply appreciate this forum...

thank you all. I do deeply appreciate this forum for all I have learned. and how it keeps to the mission of education and how nice it is NOT to have peoples personal social political thoughts...
Forum: Ignition System 08-17-2018, 01:24 PM
Replies: 11
Views: 3,483
Posted By azazzera
I don’t know if it’s just me but the rule of 2011...

I don’t know if it’s just me but the rule of 2011 link comes back to file not found.
Forum: Ignition System 08-17-2018, 01:12 PM
Replies: 11
Views: 3,483
Posted By azazzera
Dose any one know what or were I could find the...

Dose any one know what or were I could find the specifications for the mmi coil?
Should we not know the published numbers for a starting point. 10% +\_ is understood but we should know the...
Showing results 1 to 25 of 255

 
Forum Jump

All times are GMT -4. The time now is 04:21 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved