Forum: Troubleshooting
10-31-2009, 12:34 PM
|
Replies: 8
Views: 3,289
|
Forum: Troubleshooting
10-31-2009, 11:50 AM
|
Replies: 8
Views: 3,289
|
Forum: Troubleshooting
10-31-2009, 11:02 AM
|
Replies: 8
Views: 3,289
No Oil Pressure
Dan, the pump was cleaned when the old elbow was taken out. I cranked the motor for about a total of 4-5 minutes, 30-60 seconds at a time. I really hate the thought of taking everything apart again....
|
Forum: Troubleshooting
10-31-2009, 08:45 AM
|
Replies: 8
Views: 3,289
No Oil Pressure
After a total rebuild and double checking all the steps, I can't get any oil pressure when I bench tested. Five and 1/2 quarts in the pan, all journal plugs in, new screen elbow and just a trickle of...
|
Forum: Troubleshooting
10-27-2008, 10:16 AM
|
Replies: 7
Views: 5,360
Don, you were right again. I went down to the...
Don, you were right again. I went down to the boat Sunday and removed the main passage plug and main jet. Some flecks of crud came out and the jet was partially clogged. I carb cleaned all the...
|
Forum: Troubleshooting
10-20-2008, 10:36 AM
|
Replies: 7
Views: 5,360
|
Forum: Troubleshooting
10-06-2008, 05:27 PM
|
Replies: 7
Views: 5,360
|
Forum: Troubleshooting
09-08-2008, 02:33 PM
|
Replies: 7
Views: 5,360
Now Running Rough
Brought the boat back to the dock under power and engine had run fine all day. A strong wind was coming from astern so I put it in reverse to slow it down a little. It popped out of reverse and the...
|
Forum: General Maintenance
11-20-2006, 02:18 PM
|
Replies: 112
Views: 168,908
antifreeze in the block
Is it possible to remove the rear block drain plug and the thermostat housing and pour antifreeze directly into the block until it comes out the plug and then retighten? Just a thought.
|