Forum: Ignition System
02-22-2023, 10:28 AM
|
Replies: 18
Views: 3,739
Switch?
Eliminate the possibility the switch is faulty...I had the similar problem and chased everything for days and it turned out to be the switch that would turn the starter, but not make connection to...
|
Forum: General Maintenance
07-24-2021, 11:14 AM
|
Replies: 3
Views: 1,302
Mechanical Fuel Pump Rebuild Instructions
Does someone have a set of rebuild instructions they could share or are they available online somewhere. I bought a “when i need it” kit a number of years ago but the instructions got separated from...
|
Forum: Troubleshooting
12-27-2020, 11:33 AM
|
Replies: 16
Views: 2,245
Ignition Switch??
Another possibility, from experience...check the continuity of the switch in the "run" position. May have continuity in the "start" position to turn the starter but none in the "run".
|
Forum: Fuel System
08-05-2020, 05:23 PM
|
Replies: 5
Views: 2,067
Fuel line pressure gauge
Does anyone have pictures of how they installed their fuel line pressure gauge? Any do's and don't's about the installation? thanks!
|
Forum: Ignition System
07-30-2020, 04:20 PM
|
Replies: 6
Views: 1,790
No joy
Put different condenser and coil in And no luck
|
Forum: Ignition System
07-30-2020, 03:03 PM
|
Replies: 6
Views: 1,790
So far
Fuel cover loosened..will try new condensor and try again. Coil new last fall...one off of “the list”.
|
Forum: Ignition System
07-30-2020, 01:52 PM
|
Replies: 6
Views: 1,790
Where do i start?
I am out on the water and the engine cuts out.... took apart and checked the carburetor and fuel Is good. Cleaned up points they weren’t bad. Ran yesterday for 8 hours With acouple of shut downs be...
|
Forum: Electrical
06-28-2020, 08:13 AM
|
Replies: 3
Views: 1,805
|
Forum: General Interest
10-28-2019, 08:38 PM
|
Replies: 2
Views: 1,766
|
Forum: Troubleshooting
07-30-2019, 10:11 AM
|
Replies: 15
Views: 4,571
|
Forum: Troubleshooting
07-29-2019, 11:30 AM
|
Replies: 15
Views: 4,571
|
Forum: Troubleshooting
07-29-2019, 11:27 AM
|
Replies: 15
Views: 4,571
|
Forum: Troubleshooting
07-27-2019, 10:09 PM
|
Replies: 15
Views: 4,571
|
Forum: General Interest
10-19-2017, 07:40 PM
|
Replies: 17
Views: 6,609
|
Forum: Fuel System
08-15-2017, 09:39 PM
|
Replies: 3
Views: 1,862
Carb ckeaning
I have attach a picture of the top of carb. My focus is the small circular brass "cap" inset down in the venturi. My question, does that "cap" have a hole in it? If so, where does the passage lead...
|
Forum: Fuel System
04-30-2017, 08:52 PM
|
Replies: 38
Views: 12,665
Key Switch
Check your key switch to rule that out...speaking from experience after days of what you are doing. may have connection in start position, but none in run position
|
Forum: Troubleshooting
07-02-2015, 02:16 PM
|
Replies: 4
Views: 2,511
A number of years ago, we had a spinning, but no...
A number of years ago, we had a spinning, but no start situation...even had spark at the plug while spinning. We spent days trouble shooting, checking wires, new plugs, points, condenser, wires,...
|
Forum: General Maintenance
05-19-2015, 02:09 PM
|
Replies: 3
Views: 2,546
Gasket only or Gasket and "sealer"
I am replacing the both of reversing gear housing and the accessory drive gaskets.. The last time it was done there was some type of sealer used...is it necessary to use sealer? thanks, pck
|
Forum: Drive Train / Propellers
04-27-2015, 07:36 PM
|
Replies: 8
Views: 8,895
can relate to cutlass bearing replacement
Just got home from the boat after a day of removing the accessory drive and replacing the oil seal. Then started the cutlass bearing and rear oil seal replacement. On a Morgan 35, cutting the shaft...
|
Forum: General Interest
08-14-2014, 04:15 PM
|
Replies: 2
Views: 4,365
Engine sputtering after runinng 4 hours
running a no frills engine, standard points ignition... only add is oil and temp warning system.....we are out on a trip..first leg of 11 hours of motoring went fine, not a hick-up..second leg of...
|
Forum: Troubleshooting
07-12-2013, 07:24 AM
|
Replies: 23
Views: 4,559
|
Forum: Electrical
05-12-2013, 04:30 PM
|
Replies: 34
Views: 19,237
"Trailer Connector"
I had the same "trailer" connector in our '72 Morgan 35. It was the factory connector. Ours had one end having much shorter tails with the connections to the various gauges. That connector allowed...
|
Forum: Fuel System
03-15-2013, 03:29 PM
|
Replies: 3
Views: 2,646
In-line fuel flow meter/gauge
Is there a fuel meter/gauge i can install on the fuel line to serve as a fuel monitor/meter/gauge that is compatible with the A-4?
I do not have a gauge in my tank, nor anyway of know how much...
|
Forum: Troubleshooting
07-16-2011, 09:47 PM
|
Replies: 14
Views: 6,722
something else to check
double check ignition switch, may have conductivity in the crank/start position but be "dead" in the run position...that is what happened to us, spent days tracking everything else...your symptoms...
|
Forum: Ignition System
06-28-2011, 08:25 PM
|
Replies: 32
Views: 12,762
no spark...
check the ignition switch...spent weeks hunting for no start even when there was fuel and spark, turned out that ignition made connection in cranking position, but dead in the run position...replaced...
|