Moyer Marine Atomic 4 Community - Home of the Afourians

Moyer Marine Atomic 4 Community - Home of the Afourians (https://www.moyermarineforum.com/forums/index.php)
-   Aftermarket Kits and Accessories (https://www.moyermarineforum.com/forums/forumdisplay.php?f=23)
-   -   Alarm questions (https://www.moyermarineforum.com/forums/showthread.php?t=10603)

Marty Levenson 03-01-2018 12:45 PM

Alarm questions
 
I am wanting to install a low oil pressure/high water temp alarm. One day I may upgrade to the full EDWS.

Shipping to Canada (plus $ exchange) is quite expensive, and my local chandlery only sells the Sierra brand alarm. It triggers at 6 psi or 200 degrees.

Does anyone have experience with their alarm?
How hard is it to install compared to Cole Hersee?
Anyone have a Canadian (Vancouver?) source for the Cole Hersee?
Down the road will it be compatible with the Moyer EDWS?

Also - wondering about a flow alarm on the FWC. Anyone go that route? Be good to know the Indigo/Johnson electric pump has failed a few minutes before she starts overheating. I was thinking of wiring it to the same alarm....?

Thanks!

joe_db 03-01-2018 03:00 PM

The Sierra parts are probably about the same and should fit in with the EWDS. I would think twice about using a flow alarm in the FWC loop, those pumps are VERY sensitive to any restrictions in flow. If you do it, take careful note of any increase in temperatures.

Marty Levenson 03-01-2018 03:35 PM

FW flow
 
Thanks, Joe. Now I wonder if restriction might age the pump faster, even if no temp increase?

ndutton 03-01-2018 07:51 PM

By volume/time measurement the MMI flow sensor imparts a 7% restriction when in an impeller pump system. As far as I know there have been no tests done for the Johnson CM30P-7 electric pump that is popular for FWC. The flow sensor operating temp spec is 250°F. That doesn't leave much margin of safety temperature-wise.

If you try to source a different flow sensor with hopes of using it in the future with the EWDS, the contacts must be NC.

HOTFLASH 03-01-2018 11:19 PM

Low oil pressure/Hi water temp
 
VDO makes gauges that include, with the appropriate VDO sender, visual in-gauge alarms that can also be used with the cole hersee/Moyer Marine buzzer alarm. I purchased mine thru Fisheries Supply.
Mary
T27 Yawl
HotFlash

joe_db 03-02-2018 07:50 AM

Quote:

Originally Posted by HOTFLASH (Post 111081)
VDO makes gauges that include, with the appropriate VDO sender, visual in-gauge alarms that can also be used with the cole hersee/Moyer Marine buzzer alarm. I purchased mine thru Fisheries Supply.
Mary
T27 Yawl
HotFlash

Please note VDO uses different senders than the USA standard. If you go this way, you need the senders too.
My fuel pressure gauge has one of these warning lights in it that goes off below 1 PSI. I like the concept.

* I have one of these:
https://www.amazon.com/Standard-Moto.../dp/B00153AZWY
It runs the alarm and OPSS functions both, so it saves me an extra port and plumbing.


All times are GMT -4. The time now is 07:04 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved