Raw Water Intake and Temp
I have an early model A4 with no gauge for water temp, is there a kit to add one to it? Seems like the engine is running a bit hot. And is there a standard size for the raw water intake? Mine has a copper line but doesn't look very large.
|
https://moyermarine.com/product/issp...e-gaug_09_178/
https://moyermarine.com/product/issp...2-gaug_10_179/ The inside diameter of the hoses/pipes/tubes in and out of the pump will certainly have an effect on its performance. The typical pipe I.D. used with our raw water pumps is 3/8" nominal, hose I.D. is usually 5/8". |
Thanks Neil! Is that 5/8 ID hose usually what is connected to the thru hull fitting? Thank you for the links.
John |
On my early model the temp sensor is installed using a T at the water exit of the manifold. http://www.moyermarineforum.com/foru...&pictureid=617
Dan S/V Marian Claire |
Quote:
|
All times are GMT -4. The time now is 10:07 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved