Female threads on inline exhaust water injector
Right now the treads on the inline water injector are 1 1/4" male, which require a coupling to attach at the end of a pipe section. If the fitting were made with female threads, the need for the extra fitting would go away.
|
Why not go back up to the 45 and install the injector fitting there?
|
All times are GMT -4. The time now is 07:46 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved