Installing Electronic Ignition
Hi All
I just installed the Pertronix 1146a electronic ignition on my Atomic 4 and used the opportunity to film the step by step. https://youtu.be/jcdBjA7QTDc Hopefully that helps someone down the line... Cheers Chris |
yes it was help full
this video was very help full ... I am thinking about switching over
|
Thanks! I do notice a difference in the way she runs.
Buddy next to me did it today, and had no issues putting the collar down; so that seems to be a bit random. Good Luck |
Been sitting on the fence, but just ordered the kit.
|
Sometimes, if the magnetic collar is too high up on the shaft it impedes the rotor's key from locking into the shaft and it spins freely.
The other issue is (if you broke off the tabs to allow the collar to slide down the shaft a bit) you can get the collar too far down on the shaft and it won't line up with the trigger device on the 1146a. I've been happy with my EI once I worked out the bugs. Just things to think about if you are having trouble. :) |
Thanks for the vid!
|
I think we could use a section where all helpful videos are linked :D
|
Done! Thanks for the idea, Greg.
Bill |
All times are GMT -4. The time now is 05:43 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Universal® is a registered trademark of Westerbeke Corporation
Copyright © 2004-2024 Moyer Marine Inc.
All Rights Reserved