Moyer Marine Atomic 4 Community - Home of the Afourians

Moyer Marine Atomic 4 Community - Home of the Afourians (https://www.moyermarineforum.com/forums/index.php)
-   Ignition System (https://www.moyermarineforum.com/forums/forumdisplay.php?f=16)
-   -   Coil corrosion (https://www.moyermarineforum.com/forums/showthread.php?t=10687)

Skywalker 05-14-2018 08:54 AM

Coil corrosion
 
Hi guys, been a while. Life has offered many challenges over the past year, but it's back to boating now!

Last summer, I ran aground, got pushed up on a sand bar on a strong incoming tide. The force of the current pushed foamy water up the tube for my center board pennant and spilled onto the back of my A4. I didn't realize this at first, so I did not clean up the mess.

Over the winter, I noticed that my coil, which was only a season or two old, was corroded, so I bought a new one even though it was working apparently well.

The boats in the water now, running well with the new coil. I took the old one home, brushed off the rust with a wire wheel, and gave it a coat of rustoleum. Put the meter to it and got 3 ohms of resistance.

My question is, how durable are these bad boys? I'm debating putting this one back in and putting the new one in the spare parts box.

Any thoughts?

ndutton 05-14-2018 09:04 AM

Even though we have no evidence other than outward appearance the old coil may have been damaged, my vote is fuhget about it. The goal is a reliable engine so you want to have known-good components both installed and in the spares locker. Compared to boating expenses in general, the value of a suspect coil is peanuts.


All times are GMT -4. The time now is 04:47 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved