Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 25 of 213
Search took 0.02 seconds.
Search: Posts Made By: Easy Rider
Forum: Announcements 04-02-2024, 10:41 PM
Replies: 8
Views: 414
Posted By hanleyclifford
Exclamation Both Moyer Marine and this Forum are essential to...

Both Moyer Marine and this Forum are essential to the continuation of the Atomic 4 as a resource into the future. The loss of either would be a disaster.
Forum: Announcements 04-02-2024, 05:45 PM
Replies: 8
Views: 414
Posted By thatch
Coinnection point

The "Moyer site" has been my connection point for some really great guys. I have made friendships, gained knowledge and improved my boating experience because of it. Hopefully, it will continue for...
Forum: Announcements 04-02-2024, 10:55 AM
Replies: 8
Views: 414
Posted By B Moyer
UPDATE

All,
We are frustrated beyond tears at the rate in which this update is taking. There are many facets to be worked out and we thought everything was ready to move forward when we posted the Notice....
Forum: Overhaul 03-13-2024, 08:30 PM
Replies: 4
Views: 312
Posted By Al Schober
Last engine I went through, I looked at the same...

Last engine I went through, I looked at the same thing. I wasn't able to find a 'portable' mechanic, and also considered buying multiple tools from Goodson.
Ended up taking the block to a machine...
Forum: Cooling System 03-05-2024, 07:52 PM
Replies: 4
Views: 486
Posted By whalechaser
Thanks, I sandblasted it and brought it to a...

Thanks, I sandblasted it and brought it to a metal fab shop, they brazed it for $50.

Cheers,

Chris
Forum: Announcements 02-22-2024, 04:55 PM
Replies: 8
Views: 414
Posted By B Moyer
Forum update reply

All,
This may be the only noitce we will be able to give you. However, be assured if we get advanced notice we will do our best to notify the forum too.
Forum: Ignition System 02-19-2024, 04:33 PM
Replies: 4
Views: 289
Posted By hanleyclifford
It is okay to buy stuff for the A4 at auto parts...

It is okay to buy stuff for the A4 at auto parts stores but don't expect them to know what you need. Inquire at Moyer Marine first.
Forum: General Maintenance 01-08-2024, 09:26 PM
Replies: 18
Views: 859
Posted By hanleyclifford
Yes, and those studs should be checked for loss...

Yes, and those studs should be checked for loss of material / thread. 4 threads minimum should remain, and I always set the stud with thick Permatex.
Forum: General Interest 01-01-2024, 07:08 PM
Replies: 9
Views: 1,087
Posted By TimBSmith
Happy New Year

Thankful for this community. All the very best in 2024.
Forum: General Interest 12-24-2023, 03:06 PM
Replies: 1
Views: 670
Posted By hanleyclifford
And thanks to Moyer Marine for saving the Atomic...

And thanks to Moyer Marine for saving the Atomic 4 from oblivion and supporting us throughout the years.
Forum: General Interest 12-24-2023, 01:49 PM
Replies: 1
Views: 670
Posted By B Moyer
Blessings and Gratitude

A huge heartfelt thank you to all who give of themselves helping all members of our Forum throughout the years. 2023 has been a year filled with excitement and changes and we feel blessed to have so...
Forum: General Interest 12-17-2023, 01:14 PM
Replies: 4
Views: 667
Posted By Bayou Sailor
KISS

I just wanted to drop a quick note about keeping it simple. Down here in south Louisiana, we pretty much sail all year. Well, this summer Margarita started and ran about as good as you could ask...
Forum: Cooling System 12-12-2023, 11:08 AM
Replies: 7
Views: 5,766
Posted By Al Schober
The other advantage of glycol cooling is that you...

The other advantage of glycol cooling is that you don't have to worry about winterizing the engine! This will appeal to those in Northern climes.
Only disadvantage is that you need a system free of...
Forum: Troubleshooting 12-02-2023, 06:56 PM
Replies: 28
Views: 7,324
Posted By Dave Neptune
Yes water should gush out depending on how far...

Yes water should gush out depending on how far below the waterline.

Did you rebuild your water pump or replace the impeller? If so did you check the width of the impeller? If it does not fit snug...
Forum: Cooling System 11-26-2023, 04:28 PM
Replies: 5
Views: 4,343
Posted By Al Schober
Personally, I used brass (local hardware store)...

Personally, I used brass (local hardware store) for 30+ years without issue. Bronze or stainless would be better but difficult to source. First try would be McMaster.
Another consideration (while...
Forum: Cooling System 11-15-2023, 07:20 AM
Replies: 7
Views: 3,109
Posted By W2ET
The spec on Shawn's pump says it draws 27 watts. ...

The spec on Shawn's pump says it draws 27 watts. That's all but zero in HP terms. The engine would never know that load was present.

Bill
Forum: Troubleshooting 11-08-2023, 05:58 PM
Replies: 43
Views: 14,453
Posted By hanleyclifford
He's right; it would work - IF it had the correct...

He's right; it would work - IF it had the correct resistance in front of it. In fact just about any "12" volt auto coil will fire the A4 but buying the coil from Moyer Marine takes the guesswork out...
Forum: Introductions 11-05-2023, 09:39 AM
Replies: 8
Views: 1,528
Posted By ndutton
Welcome Steve. Do you have the Moyer...

Welcome Steve.

Do you have the Moyer Marine engine manual yet? It's a good, almost mandatory, first purchase from the Moyer Marine Online Store. Stay up on your maintenance, proper...
Forum: Fuel System 11-01-2023, 07:15 PM
Replies: 14
Views: 1,932
Posted By sastanley
I agree with most everyone else. One step at a...

I agree with most everyone else. One step at a time and get it running better first. EI won't solve any issues.
Forum: Electrical 10-16-2023, 03:06 PM
Replies: 7
Views: 1,015
Posted By msmith10
Bill, I doubt any of those responses would...

Bill,
I doubt any of those responses would please your wife. Try one of these:
"It will make the boat smell better"
"It keeps mice and cockroaches off the boat"
"It is for setting up a central...
Forum: Troubleshooting 10-09-2023, 11:00 PM
Replies: 17
Views: 1,841
Posted By thatch
"Four"ensics

Jim, Please don't beat yourself up too badly over misreading this engine's problem. It is quite common for the group to speculate widely before homing in at the root of a problem before collectively...
Forum: Troubleshooting 10-07-2023, 10:20 AM
Replies: 17
Views: 1,841
Posted By thatch
Terminal

Hi, And a rather "dubious", welcome to the forum. Dave's assessment of what those parts are is correct. A quick look at my "paperweight A4 piston" verified that the round object is definitely the...
Forum: General Interest 09-11-2023, 01:25 PM
Replies: 3
Views: 752
Posted By W2ET
FDNY FF Joseph "Toolie" O'Toole

Firefighter Joseph “Toolie” O'Toole, age 61, of the FDNY, died on Dec. 12, 2016, from an illness related to his response to the World Trade Center on 9/11. The forum remembers his birthday, but on...
Forum: Troubleshooting 09-06-2023, 12:44 PM
Replies: 35
Views: 4,020
Posted By Bents
Final Update

First of, thank you everyone for the help! I've learned a heck of a lot in the first month of boat ownership lol.

Replacing the solenoid was not the issue, but it was the lowest cost step in the...
Forum: For Sale - Engines and Engine Parts 08-30-2023, 07:47 PM
Replies: 1
Views: 617
Posted By Dave Neptune
For what it is worth, there was probably nothing...

For what it is worth, there was probably nothing wrong with reverse. Nine times out of ten when someone complains about power in reverse it is usually a new owner unaware that to engage reverse...
Showing results 1 to 25 of 213

 
Forum Jump

All times are GMT -4. The time now is 10:25 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved