Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 4 of 4
Search took 0.01 seconds.
Search: Posts Made By: msauntry
Forum: Drawings and Schematics 11-28-2011, 08:41 PM
Replies: 42
Views: 46,206
Posted By msauntry
FYI- You can tell if you've burned up your...

FYI- You can tell if you've burned up your Pertronix module because it has a sticker on it that is temperature sensitive. It'll be melted if the unit has failed.
I believe this only applies to the...
Forum: Cooling System 11-28-2010, 08:30 PM
Replies: 86
Views: 99,496
Posted By msauntry
Just installed mine and it is powered off the...

Just installed mine and it is powered off the ignition circuit instead of the oil pressure switch. The pump spins when the key is turned, but so what? Is there a danger in that?
Thanks,
Micah
Forum: Troubleshooting 08-01-2008, 09:59 AM
Replies: 64
Views: 65,729
Posted By msauntry
Get Better Access.

You're close...Keep going till you get it. Get the carb off and clean it.
That should fix the fuel problem. Can't get the carb off? Remove whatever obstacles are in your way.

Spark- 3-4 ohms...
Forum: General Interest 05-21-2008, 06:35 PM
Replies: 8
Views: 15,222
Posted By msauntry
plugs

I had similar experiences with the plug and wires that you did and found the same results. The J8C's ran fine and the RJ12Cs (and the NGK brand plugs) ran poor, and I had new wires. Mine was on the...
Showing results 1 to 4 of 4

 
Forum Jump

All times are GMT -4. The time now is 07:47 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved