Forum: Overhaul
02-04-2021, 09:30 PM
|
Replies: 4
Views: 2,056
I'll try to help..
If the head is still...
I'll try to help..
If the head is still installed, give the water jacket and head a pressure test. You're looking for cracks and cylinder porosity. Do these yourself - low cost.
If the head is...
|
Forum: Overhaul
01-16-2021, 10:06 AM
|
Replies: 5
Views: 2,160
Hello Splashdog.
I'm not sure it will help...
Hello Splashdog.
I'm not sure it will help with your situation, but below is a link to drawings that show the locations of the mounting holes for a late model A4. I've highlighted the hole...
|
Forum: Overhaul
01-15-2021, 07:40 PM
|
Replies: 5
Views: 2,160
I can give a little feedback but suggest you...
I can give a little feedback but suggest you double check. I have a 1966 Morgan 34 w/original A4- ie "early model" Back in my youthful days about 30yrs ago I bought a rebuilt short block A4. I did...
|
Forum: General Interest
07-30-2020, 10:11 PM
|
Replies: 16
Views: 3,766
|
Forum: General Interest
07-30-2020, 09:52 PM
|
Replies: 16
Views: 3,766
|
Forum: General Interest
07-30-2020, 07:32 PM
|
Replies: 16
Views: 3,766
|
Forum: Overhaul
07-22-2020, 12:28 AM
|
Replies: 2
Views: 1,934
I just tore into it :D
I did however make...
I just tore into it :D
I did however make notes, took lots of pics and arraigned the lifters and springs in order from 1-8 from flywheel to aft.
I'm sure a more learned approach will by posted for...
|
Forum: General Interest
07-20-2020, 02:56 AM
|
Replies: 8
Views: 4,396
When you changed fuel lines, did you change...
When you changed fuel lines, did you change filters? Try opening your fuel fill cap, in case your fuel tank vent is clogged, and the pump can't draw fuel. Once you get a fuel pressure gauge, you can...
|
Forum: General Interest
07-14-2020, 03:14 PM
|
Replies: 8
Views: 4,396
well, carb is designed to run on 1-2psi, most...
well, carb is designed to run on 1-2psi, most folks have Facet pumps [Moyer] 1-3psi to 2-4psi range. 4psi+ is for long fuel runs from the tank. Not having some kind of filter [10 to 40 micron]...
|
Forum: General Interest
07-13-2020, 11:12 PM
|
Replies: 8
Views: 4,396
|
Forum: General Interest
07-13-2020, 08:39 PM
|
Replies: 8
Views: 4,396
|
Forum: General Interest
07-13-2020, 06:20 PM
|
Replies: 8
Views: 4,396
|
Forum: General Interest
11-03-2019, 01:53 PM
|
Replies: 9
Views: 4,496
What you did is the equivalent of extended...
What you did is the equivalent of extended cranking with the seacock open. The pump pushed antifreeze thru the system until the waterlift muffler filled up. With no exhaust pressure to empty the...
|
Forum: Electrical
10-09-2019, 08:11 PM
|
Replies: 15
Views: 6,708
To me little Prestolite dizzy [w/condenser...
To me little Prestolite dizzy [w/condenser hanging on side and oil cup] means early model. Detail steps are spelled out in Moyer tech pages. Basically, pull the distributor, get to TDC on...
|
Forum: Electrical
10-09-2019, 07:56 PM
|
Replies: 15
Views: 6,708
|
Forum: Electrical
10-09-2019, 04:28 AM
|
Replies: 15
Views: 6,708
Yes, all correct but please know that the mark...
Yes, all correct but please know that the mark you made for the top of the compression stroke will also indicate the top of the exhaust stroke. When setting the timing initially it is imperative you...
|
Forum: Troubleshooting
09-11-2019, 09:36 AM
|
Replies: 6
Views: 4,611
|
Forum: Troubleshooting
08-26-2019, 09:24 AM
|
Replies: 16
Views: 6,152
|
Forum: Troubleshooting
08-24-2019, 10:47 PM
|
Replies: 16
Views: 6,152
|
Forum: Troubleshooting
08-24-2019, 10:40 PM
|
Replies: 16
Views: 6,152
Not to long ago, I installed EI into my late...
Not to long ago, I installed EI into my late model A4. Pulled points/plate and installed EI plate. Installed ring around the shaft..put it back together. Cranked, got nothing.
Pulled cap off...
|
Forum: General Interest
08-16-2019, 09:52 PM
|
Replies: 22
Views: 8,355
Unknown at the moment. A yellow spark is not...
Unknown at the moment. A yellow spark is not good.
The first thing I would do is be sure there is enough voltage to the coil.
Take a voltage reading across the battery posts. Leave the probe on...
|
Forum: General Interest
08-15-2019, 11:07 AM
|
Replies: 22
Views: 8,355
|