Forum: Electrical
01-10-2024, 03:22 PM
|
Replies: 6
Views: 1,248
|
Forum: Fuel System
10-16-2023, 04:17 PM
|
Replies: 3
Views: 605
Personally I don't like using thread tape, even...
Personally I don't like using thread tape, even if gas rated in case the threads cut and little pieces may end up in flow (and yes I have filters :cool: ). I use Permatex Aviation Form-A-Gasket on...
|
Forum: Troubleshooting
06-19-2023, 04:23 PM
|
Replies: 8
Views: 935
|
Forum: General Maintenance
04-04-2023, 04:04 PM
|
Replies: 7
Views: 1,588
|
Forum: Overhaul
03-17-2023, 04:29 PM
|
Replies: 13
Views: 4,189
|
Forum: Cooling System
02-28-2023, 04:11 PM
|
Replies: 29
Views: 4,314
|
Forum: Fuel System
02-06-2023, 04:32 PM
|
Replies: 16
Views: 1,919
|
Forum: Fuel System
09-15-2022, 04:38 PM
|
Replies: 4
Views: 1,259
|
Forum: Overhaul
05-18-2022, 12:21 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
05-10-2022, 01:05 PM
|
Replies: 123
Views: 29,388
ok, recleaned the carb and did the Dizzy...
ok, recleaned the carb and did the Dizzy alignment trick as mentioned in the thread Neil linked to and started with the carb needle adjustment at 1 full turn out. Currently it is idling non-stop at...
|
Forum: Overhaul
04-21-2022, 08:34 AM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
04-20-2022, 09:01 AM
|
Replies: 123
Views: 29,388
- I didn't even get a burp out of the oil...
- I didn't even get a burp out of the oil pressure gauge when cranking or running on both the electrical and mechanical gauge. Maybe someone can confirm that with the mechanical gauge, does one need...
|
Forum: Overhaul
04-19-2022, 09:01 AM
|
Replies: 123
Views: 29,388
Cheap mechanical oil gauge didn't twitch.
...
Cheap mechanical oil gauge didn't twitch.
Dropping the oil pan! Hoping I can leave it on the rolling cart and "just undo" the pan bolts (and 'flywheel'), then hoist the block high enough to...
|
Forum: Overhaul
04-17-2022, 02:54 PM
|
Replies: 123
Views: 29,388
Fired up the engine today
- When you think...
Fired up the engine today
- When you think you've placed the ignition wires in the correct order, check again. Then one more time. :rolleyes:
- water temp gauge not reading but not surprising...
|
Forum: Overhaul
04-13-2022, 08:43 AM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
03-30-2022, 04:22 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
03-25-2022, 12:10 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
03-21-2022, 07:49 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
03-21-2022, 07:48 PM
|
Replies: 123
Views: 29,388
|
Forum: Fuel System
03-17-2022, 03:09 PM
|
Replies: 21
Views: 3,175
Steve;
While you are adding new fuel hose...
Steve;
While you are adding new fuel hose and polishing filter between the pump and carb, think about also adding a fuel pressure gauge in this location too. It comes in hand when troubleshooting!
|
Forum: General Interest
11-24-2021, 11:47 AM
|
Replies: 1
Views: 1,160
|
Forum: Cooling System
11-22-2021, 09:00 AM
|
Replies: 6
Views: 2,284
|
Forum: Overhaul
11-08-2021, 12:40 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
11-03-2021, 04:33 PM
|
Replies: 123
Views: 29,388
|
Forum: Overhaul
11-03-2021, 04:28 PM
|
Replies: 123
Views: 29,388
|