Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums

Showing results 1 to 25 of 30
Search took 0.01 seconds.
Search: Posts Made By: wristwister
Forum: Polls 07-24-2020, 09:03 PM
Replies: 61
Poll: Engine Color
Views: 44,981
Posted By wristwister
I believe I fall squarely in the "Something else"...

I believe I fall squarely in the "Something else" category

http://www.moyermarineforum.com/forums/picture.php?albumid=137&pictureid=1961
Forum: Overhaul 04-20-2020, 08:38 PM
Replies: 4
Views: 2,048
Posted By wristwister
I ran mine with no muffler after rebuild,...

I ran mine with no muffler after rebuild, including putting an hour or so on it for the break-in oil. Here's my post with some audio. Not too noisy at all, as far as I know none of my neighbors...
Forum: General Interest 01-16-2020, 12:37 PM
Replies: 167
Views: 45,662
Posted By wristwister
Great story Ando, and similar to many of us...

Great story Ando, and similar to many of us who've had to "learn by doing" on these A4's. My story is similar to yours, except my knocking turned into an errant connecting rod blasting a hole through...
Forum: Overhaul 11-06-2019, 10:57 AM
Replies: 185
Views: 49,033
Posted By wristwister
Sercouf, As I read through this thread, I'm...

Sercouf,

As I read through this thread, I'm not clear what your intention is here. Are you looking to do the absolute minimum just to get the engine running again, then put it back in the boat? Or...
Forum: Overhaul 10-15-2019, 10:33 AM
Replies: 152
Views: 59,004
Posted By wristwister
Alright Jonathan! At this point in the story it...

Alright Jonathan! At this point in the story it seems there's a little light at the end of the tunnel, but I'm guessing we're in for some more twists and turns as this story unfolds.

As you know...
Forum: Overhaul 09-25-2019, 02:53 PM
Replies: 16
Views: 5,019
Posted By wristwister
Laura, One plus here is that it's been...

Laura,

One plus here is that it's been sitting in the dry desert for 12 years, as opposed to a wet, salty environment like most other boats. Rust is the issue, and if that's not too bad in your...
Forum: Troubleshooting 09-17-2019, 03:57 PM
Replies: 41
Views: 16,050
Posted By wristwister
Before diving into that exhaust manifold gasket,...

Before diving into that exhaust manifold gasket, you should be able to easily confirm that this is indeed an exhaust leak. If you feel around the joint between the block and the exhaust manifold...
Forum: Troubleshooting 09-16-2019, 09:29 PM
Replies: 41
Views: 16,050
Posted By wristwister
In your original post you mentioned oil pressure...

In your original post you mentioned oil pressure dropping ~30% when the tapping started, right? When you depower #4 the tapping stops. I'm not seeing how these are related to valve adjustment. I hate...
Forum: Electrical 03-26-2019, 03:49 PM
Replies: 20
Views: 6,638
Posted By wristwister
Same here. Alternator charges both batteries...

Same here. Alternator charges both batteries regardless of switch position. Same thing with the charger (dual battery output). The switch only governs which battery(s) the juice flows out of....
Forum: Electrical 03-01-2019, 03:55 PM
Replies: 21
Views: 5,894
Posted By wristwister
Yup, I was kidding. I may not be the sharpest...

Yup, I was kidding. I may not be the sharpest knife in the drawer, but I gave up on inventing the perpetual motion machine long ago. And I did try! When I was a kid, I taped my bicycle headlight...
Forum: Troubleshooting 09-14-2018, 01:19 PM
Replies: 128
Views: 31,952
Posted By wristwister
Here, let me fix that for you: We did not...

Here, let me fix that for you:

We did not realize that you have to be willing to learn some basic mechanics to own an older sailboat with any inboard engine.
Forum: Troubleshooting 09-11-2018, 10:21 AM
Replies: 128
Views: 31,952
Posted By wristwister
When you come back to the boat and it won't...

When you come back to the boat and it won't start, do you squirt a little starting fluid down the carb to see if it will kick over that way? I'd highly suggest it. One of 3 things will happen:

1....
Forum: Overhaul 08-29-2018, 07:02 PM
Replies: 9
Views: 6,273
Posted By wristwister
When I rebuilt an A4 for my daughter's boat, I...

When I rebuilt an A4 for my daughter's boat, I was advised to do all the assembly first, including all covers, then paint the whole thing. This makes good sense, as all those edges get completely...
Forum: Ignition System 08-06-2018, 11:23 PM
Replies: 9
Views: 3,037
Posted By wristwister
Of all the upgrades available for our old A4s, in...

Of all the upgrades available for our old A4s, in my opinion the best one is the electronic ignition module. $100 and change from Moyer, minutes to install, ignition related problems gone forever.
Forum: Overhaul 05-28-2018, 11:48 PM
Replies: 40
Views: 12,642
Posted By wristwister
So ... I can now tie a nice bow around this whole...

So ... I can now tie a nice bow around this whole saga. Just got back from our California road trip where I spent most of the week removing my daughters old engine and installing the new engine....
Forum: General Interest 05-15-2018, 07:45 PM
Replies: 4
Views: 2,185
Posted By wristwister
Did you know these old A4s run fine on 2 cylinders?

Well ... not quite "fine", a little rough, but still ...

I just finished the rebuild of my A4, and I've been running it up to temp a few times for the break in oil. Sounded slightly rough to me,...
Forum: Overhaul 05-10-2018, 03:32 PM
Replies: 6
Views: 2,941
Posted By wristwister
Thanks Mo. I timed it by sound/smoothness, but I...

Thanks Mo. I timed it by sound/smoothness, but I plan to do the timing light thing.

... and the A4 is about as opposite of a Hemi as you can get!
Forum: Overhaul 05-10-2018, 01:05 AM
Replies: 6
Views: 2,941
Posted By wristwister
Hows she sound?

I've now run the freshly rebuilt A4 a few times. Sounds decent to me, but I'm not sure how a perfectly running unmuffled A4 should sound. I'm hoping some of you with more experience can advise me.
...
Forum: General Maintenance 05-03-2018, 09:47 AM
Replies: 6
Views: 3,640
Posted By wristwister
This just happened to me a couple days ago. Got...

This just happened to me a couple days ago. Got the rebuilt engine together, fired it up, then went back to retorque the head nuts after it was up to temp, and stripped one of the thermo studs out of...
Forum: Overhaul 05-01-2018, 09:05 PM
Replies: 40
Views: 12,642
Posted By wristwister
IT'S ALIVE! She fired right up! A little...

IT'S ALIVE!

She fired right up! A little tweaking on the distributor, adjustment of oil pressure, and she's purring like a kitten (a very large and angry kitten on steroids ... no muffler). Got...
Forum: Troubleshooting 04-18-2018, 11:57 AM
Replies: 34
Views: 9,157
Posted By wristwister
Sailr, did you ever try this? Might shortcut a...

Sailr, did you ever try this? Might shortcut a bunch of troubleshooting.
Forum: Overhaul 03-20-2018, 12:15 PM
Replies: 6
Views: 2,420
Posted By wristwister
Well then, I'm real glad I asked before I slapped...

Well then, I'm real glad I asked before I slapped this puppy back together! And had I just read that section of Don's overhaul manual I would have answered my own question. He covers all the oil...
Forum: Overhaul 03-04-2018, 08:14 PM
Replies: 40
Views: 12,642
Posted By wristwister
So here I sit at the airport waiting for a much...

So here I sit at the airport waiting for a much delayed flight, why not post an update on my A4 build!

Why am I at the airport you ask? I came down to my daughter's boat to pull all the goodies...
Forum: Troubleshooting 02-17-2018, 09:14 PM
Replies: 125
Views: 34,505
Posted By wristwister
Cajun, this caught my eye: "I suspect the...

Cajun, this caught my eye:

"I suspect the loose belt was not spinning the water pump enough."

If you have a belt driven water pump, then you must have fresh water cooling right? The primary...
Forum: Troubleshooting 02-15-2018, 03:53 PM
Replies: 125
Views: 34,505
Posted By wristwister
Great advice above in trying to get the engine to...

Great advice above in trying to get the engine to run in it's current condition. If the culprit of the compression problems is stck valves, then this might free it up. But if this doesn't solve the...
Showing results 1 to 25 of 30

 
Forum Jump

All times are GMT -4. The time now is 11:46 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved