Moyer Marine Atomic 4 Community - Home of the Afourians

		Moyer Marine Atomic 4 Community - Home of the Afourians > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.01 seconds. Search: Posts Made By: blhickson

Forum: Cooling System

10-11-2020, 09:52 PM

Replies: 17

Removed water jacket plates. Now what?

Views: 3,052

Posted By blhickson

Water jacket bolt fixes are on!

Yay, finally received the water jacket bolt repair kits this week (4) and the install did not go badly at all. I dry fitted all of them first and, after figuring out the contortions to put them in,...

Forum: Cooling System

10-04-2020, 09:27 PM

Replies: 17

Removed water jacket plates. Now what?

Views: 3,052

Posted By blhickson

Continuing cooling system clean out.

So I removed the alternator, and the cooling jacket plate and cleaned out as much crud as I could by hand and by using a small measuring spoon. That was a mess. When I was replacing the jacket plate,...

Forum: Cooling System

09-21-2020, 08:44 PM

Replies: 17

Removed water jacket plates. Now what?

Views: 3,052

Posted By blhickson

Removed water jacket plates. Now what?

Hi Afourians, hope all are well. Engine ran hot during last outing, 9/13/2020. Real hot and shut down. Got tow to home dock. The boat had been laid up in a yard for 3 yrs before being splashed Feb 22...

Forum: Cooling System

11-05-2019, 01:31 PM

Replies: 20

After long layup, no exhaust water! HELP!

Views: 6,045

Posted By blhickson

and the rest of the story...

Dear Brain Trust, thank you to everyone for the excellent intel. I was able to get water out of the exhaust, bought the IR thermometer just in case, and left that crappy boatyard once and for all. ...

Forum: General Interest

11-02-2018, 03:21 PM

Replies: 18

Hand crank vs. battery

Views: 5,236

Posted By blhickson

Thanks y'all. The boat does have 5 jackstands...

Thanks y'all. The boat does have 5 jackstands under her (had six but yard moved one to move boat next door and doubt they put it back). Thanks for the info on the prop and the cutlass bearing. I hope...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 11:22 PM.